20mm projectile 3d models

projectile for a spent 20mm cartridge

This is a 20mm M61 autocannon projectile. This model is based off of laser scan data of round. ...Reverse engineering done in geo design x.

20mm projectile that I came up with. I use them with real brass for plaques. Prints well in PLA and PETG. I print with infill with PLA and 0% infill with 3 walls in PETG. UPDATE: So the original base fit a little TOO snug. When I test fit...

A couple of 20mm US vulcan projectiles

Various 20x110mm USN projectiles

20mm Japanese Type 99 20x72rb HE-T projectile It's basically the Oerlikon design. ...Tried to detail the tracer pocket and the fuse.

A 20mm minengeschoß projectile fired from a MG 151/20.

Projectile used in Physics Lab #4

Armour-piercing projectile

Balle

Projectile point from reference collection

Projectile Point (55-B- Lopez-2 42 PPT) 3SB1176

30mm Projectile for homemade cannons. ...Manipulate to your purposes.

-Print with the top open and fill with plaster for an inert round -Or print upside down with the bottom open and fill with smoke mix -1:24 RH twist rifled projectile -Optimized for vase mode printing, 45° degree overhangs *PRINT IN VASE MODE*...

A projectile model for a small game I worked on a while ago. This was the weapon used by the main character. ...It was modelled in Maya and textured in Photoshop.

This is a projectile launcher made for use in the demonstration of projectile motion calculations. It is adjustable from 5-65 degrees in increments of 3.75 degrees. Most rubber balls fit. The blueprints should provide any other information. You may...

A small hard projectile/bullet for a DIY 1/2" PVC Blowgun. Friction fit inside the pipe provides plenty of gusto when launched. The back/bottom have holes and a concave section for weight reduction and to make it appear more aerodynamic and sexy.

A solid taginn projectile that can be use to practice accurate firing of the taginn launcher. You will have to weigh an original taginn projectile and adjust infill density to match the same weight. I recommend increasing wall line count to 6-8 and...

This projectile points were used in throwing spears. They were launched by means of a device called Estólica where one part was used for the launch, while the other was ejected towards the target. They were used to hunt animals like guanacos. It...

M107 Projectile

Tracer projectile concept

0.50 Sniper projectile

6.5 Creedmoor projectile

9 mm Projectile

a simply projectile for a air gun.

Files for my projectile launcher project

Simple design of the original Raven projectile

1.1" USA Mk1 projectile model

This projectile is based on the Ripple effect