aerofoil design 3d models

created in pro e 5.0

was going through NACA curve coordinates,so i decided to make the aerofoil by using CATIA G.S.D

Hey falks, I've desided to share what I've designed for my Jerby car, and thought maybe you can use it in your models as opposite to this stupid square that they have now. What it does: - Creates the downforce - Removes aerooscillations on high...

Clark w Wing Design from Aerofoil data and flow simulate

AEROFOIL DESIGN

aerofoil

Aerodynamic Aerofoil

Simple aerofoil wing

Request: Aerofoil shaped cad model needed http://grabcad.com/requests/aerofoil-shaped-cad-model-needed Requested by Jai Gounder

This project contain a analysis results of Aerofoil ( NACA2412).

lockheed aerofoil modelled by importing csv co ordinates

this is a simple aerofoil that can be used for any project, it has pre-cut parts for dowel supports etc.

i simply split this aerofoil into multiple sections for scaling up. ...The current size im playing around with when pieced together is around 46 inches in total per rib.any help or suggestions would be greatly appreciated

I was tired of drawing crappy aerofoils in my notebook, so here we go! ...A nice generic NACA 2415 template in both large and small for my fellow aerospace peeps ;))

I found a design that seemed good but the fuselarge was horrible and needed some work which resulted in completly re-drawing so the only thing I ended up using from the orginal design were the wings. But to give credit to that design it's here...

Played a bit with fan design using aerofoils for the blades

Aerofoil Naca0015's drowing template

The proper combination of aerofoil camber, width, and angle to provide uniform pressure and velocity from the hub to tip. ...This is the criteron of efficient axial flow fan design.

A simple aerofoil wing to test/trail/practice aerodynamics.

A simple cross section of a symmetrical aerofoil. ...Easy to print.

Boeing 747 wing (aerofoil) with flap, winglets and experimental setup for wind tunnel testing.

Good evening GrabCad community This is my first attempt to a Grabcad challenge. ... Here goes the tutorial link: http://grabcad.com/questions/how-to-model-an-aerofoil-using-coordinates-in-solidworks Hope you like it Best regards

Front mounting turtle fin for the Atto Sniper FPV frame. ... Prints without supports. Very sturdy design with airflow built in. ... Optional cable tie mount.

I designed it around a M3 x 25 screw and recessed nut for holding my design to ScottTheFalcon's, and recessing 2 M5 nuts and your choice of screw to hold it to your existing screen. depending on the material you chose and your printer, you may need...

This and these similarly designed systems can be scaled up to suit needs, and of course the wider your struts will be the greater the torque applied! Visit https://Facebook.com/PolluteFree to see other various mind blowing designs of alternative...

If you like our design and would like to build it so that it is as strong as Samson himself, then please order some 3Dynamic Systems Carbon Fiber Filament $50 for 1kg of 1.75mm diameter filament. ...To order your free sample of 3DS Carbon Fiber filament...

Boeing 737 Wing Aerofoil Attempt

NACA 0016 aerofoil with spars

Boeing 747 wing (aerofoil) frame for wind tunnel testing.

Aerofoils Ratios has been changed from leading edge to trailing edge of the wing.