ambico tripod 3d models
12484 3d models found related to ambico tripod.thingiverse
Replacement for the little rubber camera holder on an ambico tripod.
thingiverse
Replacement tip for Ambico tripod that extends to 41". ... Approximate measurements Outside(mm): 24x17x12 Inside (mm): 22x12x7
thingiverse
... angle is around 61.5° and 45mm x 45mm square. * You might have to adjust your printer to find the right size for your tripod so the latch holds. * Printed with 50% infill due to the pressure of the latch. * The dovetail angel is 64°. ...
myminifactory
This is the knob that attaches to the rack & pinion height adjustment.
thingiverse
For a fairly late model Ambico branded, all plastic quick release tripod, does not have a geared crank elevator. This tripod might not have been worth to rescue but it's lighter than my aluminum tripods, and the quick release block is kind of...
thingiverse
Ambico / Velbon / Amazon house brand and possibly other inexpensive tripods. 45mm / 1-3/4 inches square dovetail design. Gonna need a couple more... UPDATE: I printed a couple more. I found that the base plate is too large to fit on the PINHE4D...
thingiverse
Customized version of https://www.thingiverse.com/thing:2087895 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=2087895
thingiverse
Tripod Mount for Ambico 40mm. ...The other models were too big on thingiverse to fit into my tripod.
myminifactory
Tripod Mount for Ambico 40mm. ...The other models were too big on to fit into my tripod.
pinshape
SummaryTripod Mount for Ambico 40mm. ...The other models were too big on thingiverse to fit into my tripod.
thingiverse
This Ambico Model V-0552A tripod ended up in my closet, and of course the shoe was missing. So instead of looking around here I made a quick, quick release shoe for it in Fusion 360. The part that mounts at the widest point is 44mm then tapers down...
thingiverse
I used this to attach an art easel to an old tripod. ...I Had to shorten rricups alittle to get it to fit on the tripod mount " Quick Release Camera Mount for AMBICO / VELBON Tripod by schlem" top for adhesion purposes
thingiverse
To build the tripod, you would need the following components: Tripod base - x1 Tripod rod - x1 Tripod pins - x2 Tripod pin caps - x2 Tripod phone holder Main tripod component - x1 Tripod Link2 components - x3 Key1 components - x2 Centre tripod...