ar vise 3d models
26939 3d models found related to ar vise.
thingiverse
I cut off one side of the ar15 vise block by PrintedFirearm so that it would fit on a 4x4x4 printer bed. ...This is only to hold the lower receiver in the upright position and will not work to hold it upside down.
thingiverse
Fits 9mm Glock magazine wells, so it will work for all Glocks (except the small single stack ones), all AR-9 / AR-15 in 9mm. If printed with an infill of >90%, it is as sturdy as it can be. Feel free to print for yourself, friends etc. - but...
thingiverse
This is a full size model of the AR-15 Upper Receiver Vise Block The vise block has vertical holes in it. It was designed to put in 3/8 x 3 inch bolts into the holes. It is one piece. there are recessed/threaded holes running horizontally so you...
cults3d
Service vise for AR-15 rifles and other suitable compatible weapons. Facilitates cleaning and assembly of accessories. Rifle can be mounted in many different ways, see photos. Tested with Aero Precision 10.5" rifle, tactical flashlight and Vortex...
thingiverse
__________________________________________________________________________ Designed to hold an AR-15 upper receiver in a vise. It wont work if your hand guards come back over the upper too far, or if the lower is installed. I put on the original in...
thingiverse
... on their opposite side. I have not tested this design but should be significantly stronger with the bolts in place. This was created by the recommendation of ValleyWalker, and referenced Timpanzi's AR-15 version, (Thingiverse file: 4145773).
thingiverse
Original file was in inches and mag catch was off. New file is in mm and should have correct mag catch location. ...
cults3d
This is a variation on my other AR-10 Upper Receiver Vise Block. I had received some feed back that some users snapped theirs during assembly, and there was recomendations that I add the ability to add bolts. So I did. This design is designed to...