boobs mousepad 3d models
407 3d models found related to boobs mousepad.pinshape
3D printable model of the Boobs moneybox just for fun. ... Model dimensions: - height – 122.4 mm - width – 76 mm - thickness – 56.7 mm
pinshape
3D printable model of the Boobs cup just for fun. ... Model dimensions: - height – 109.7 mm - width – 113.9 mm - thickness – 62.2 mm
cults3d
Kettlebell boobs voronoi. The decor item is made in the form of a kettlebell from a female breast. The model is designed for 3D printing. The archive contains the file: stl, 3ds max, Fbx, obj. ...Thank you for choosing us)
prusaprinters
Its shaped like boobs. :) Why not? Fidget Pop 1 is hollow all the way thru, Fidget Pop 2 has an air pocket for a nice squishy feel. I recommend printing Fidget Pop 2. Both have a hole for keychain. Its made to be printed...
thingiverse
small 5" x 5" mousepad for use on bed or in situations where you would want it elevated.
thingiverse
Intended to have a mousepad epoxied to it, should create a 14x14 useable area out of a 14x17 mousepad. print on its side with supports, at 100% infill. Should ideally be printed in a Nylon PA-12 based filament, but could work well with abs or PETG. ...
thingiverse
This is a mouse pad I designed, it has a wrist rest. ...I couldn't find any mousepads on Thingiverse with a wrist rest, so I made one. ... Printed in PLA, but I'm sure it would work with TPU.
thingiverse
This is a mousepad tray for 8020 rigs. There is one for "hard pads" and one for "soft pads". ... The difference is that the hard pad tray has more holes to save plastic whereas the soft pad tray has a solid surface since a soft pad would deform in the...
thingiverse
I've included the ino (saved as a txt file, just rename) for running on an arduino nano - it uses the popular FastLED.h library and runs the following states: - STATE_BREATHE, (blue breathing) - STATE_OCEAN, (ocean colour cycling) - STATE_RAINBOW,...
thingiverse
The inner dimensions of the mousepad mount (the part that attaches to the arm of the chair) is 73.4 mm wide and 22.5 mm tall. The angle that it sits on the arm is 7.5 degrees left-to-right and 13 degrees front-to-back. The gray part of the mouse...
prusaprinters
DIY RGB mousepad using WS2812B addressable LED strips and a microcontroller.It prints in two halves, you can use LePage Ultra Gel Control Super Glue to bond the two halves or just melt the joint together after aligning. I've also read that the brown...
thingiverse
I had to squeeze in the mousepad to just barely fit, so I figured I'd make an extended platform for it. My desk is similar to this, might just be an old version of it:...