cable chain stl 3d models
405564 3d models found related to cable chain stl.thingiverse
This remix was created to fix a problem with the "Anet A8 Y-Axis Cable Chain v2" STL files not working correctly with Slic3r v1.2.9. I have repaired the STL files and they should be working correctly for both Slic3r and Cura. Also, I've included a...
thingiverse
motor mount with z axis cable chain mount v2.stl 273 kb
thingiverse
Print the following quantities: (1) z-chain-frame.stl (2) half-inch_emt_insert_2mm-rev3.stl (1) z-chain-gantry2.stl (1) half-in_emt_mount2.stl (?) cable_chain_link.stl (?) cable_chain_clip.stl Purchase Parts: (2) 6-32 x 2" screws with nuts (2) 6-32...
thingiverse
cable_chain_start.stl: 1 print. Place at top of cable chain under extruder. Underside of cables. cable_chain_start_bracket.stl: 1 print. Locks on top of cables with cable_chain_start. cable_chain_links.stl: 20 prints. Alternate top and bottom down...
thingiverse
Solidoodle specific parts I used for mounting the cable chain: barclip.stl, barclip.scad Special clip to hold a 8mm bar just above the top of the Solidoodle for the chain slide on. I needed to print this with the detect thin walls option in slic3r...
prusaprinters
Mirror z-chain-frame.stl in your slicer for right hand side. Print the following quantities: (1) z-chain-frame.stl (2) half-inch_emt_insert_2mm-rev3.stl (1) z-chain-gantry2.stl (1) half-in_emt_mount2.stl (?) cable_chain_link.stl (?)...
thingiverse
It's a mix from: https://www.thingiverse.com/thing:34048 and https://www.thingiverse.com/thing:2656747 Direct Drive Mod: Using this Direct Drive mod: https://www.thingiverse.com/thing:3386628 Cable Chain STL:...
cults3d
It's a mix from: https://www.thingiverse.com/thing:34048 and https://www.thingiverse.com/thing:2656747 Direct Drive Mod: Using this Direct Drive mod: https://www.thingiverse.com/thing:3386628 Cable Chain STL: https://www.thingiverse.com/thing:3336006...
thingiverse
... snaps on. Print time ~30 minutes each. The fitting cable chain STL included (print at 0.2 or lower for smooth movement) Did an oopsie, used the same connector on both ends :) has been fixed now and improved the extruder mount in general.
thingiverse
Open Cable Chain Easier to organize wires Use 1.75 filament to keep wires inside every cable chain
cults3d
I've made no alterations to the actual parts, i simply put together a "combo"-STL of 24 links and the two endstops from RotoScan's cable chain files.
thingiverse
Small cable chain that can be assembled around existing cable. ...Part1 and part2 should alternate.
pinshape
diseño de cable chain realizado por alumnos de la Universidad Tecnologica de Tlaxcala