cassette adapter 3d models
120365 3d models found related to cassette adapter.
thingiverse
This is a cassette adapter for "Reel to Reel" recorders. ...Thing is appropriate to replace worn-out original adapters.
thingiverse
This is an adapter ring (sizes 1-5 mm) to mount narrow (6-9 speed) Shimano® cassette sprockets to 11 speed road freewheel cassettes. In my case I needed to mount a 7-speed Shimano cassette to an 11-speed cassette mount on my Elite smart trainer. My...
thingiverse
I needed a case to keep our cassette audio adapter safe while not in use. Remixed TonyYoungBlood's Cassette Tape Case with a slot for the cord, and attached JNooo's Earbud Spool for the cord. Thank you both for the files. ... Check out our 3D Print...
thingiverse
This is an adapter that you can use to wear a cassette tape as a necklace. Simply snap the adapter into the tape's holes, and then feed a chain through the hole. May require some tweaking to snap fit properly, depending on your printer. This...
prusaprinters
My audio cassette shelf got pretty empty in the last year, but I decided to keep it and design a strange adapter instead. ...The slots are 109mm wide, 17mm high, and 52mm deep, in order to display the model cars, I added a platform extending 30mm to the...
prusaprinters
<p>This was a bit of a silly thing to make (much less spend as much time designing as I did) because the lockring tool doesn't even need the locator pin. But if yours has a 5mm pin – e.g., for an older quick-release axle – and you're working on a...
thingiverse
... files have the outer diameter reduced by 0.5mm, those should be printed without further dimension reduction. It doesn't fit much film in the cassette when using the 2-inch core, but it might be useful for those odd short ends laying in the fridge.
thingiverse
one side of a cassette tape. instructions. ... print print again turn one print over glue together
sketchfab
free 3d model adjusted to game asset for TK GamJam 2016 source: https://www.thepixellab.net/free-c4d-3d-model-cassette-tape-2-2
thingiverse
Was bored and wanted something to model, quickly made up a cassette. The model came out nice except for from stringing and artifacts left by the wood filament. Need to tweak those settings. If you make one I would love to see it, please share. ...:)...