cube 2 hypercube reddit 3d models
976362 3d models found related to cube 2 hypercube reddit.thingiverse
Replaced text with HyperCube logo. ... Used on the fan for my Duet-Wifi, but should work with any 40mm fan.
thingiverse
the new x rail adapter allows for the 400mm rails to be used on a fusebox setup, but at a distance apart that works with a hypercube carriage that allows for any hypercube accessory to be used on a FLSUN cube with Core XY at the least cost *note i...
thingiverse
Not just a hypercube...an Attention Deficit HyperCube
thingiverse
... sensible to handle for extended periods of time. As such, I made a hypercube/tesseract frame for it with the added (nerd)bonus that, if I got my maths right the overall density of the cube is approximately the same as one of plain water... ...^_^
thingiverse
... like a shadow of a cube, so two cubes could look like a shadow of a hypercube. The second one is because the shadow of a cube when the light source is above would be a square inside a square, so the shadow of a hypercube is a cube inside a cube.
thingiverse
BOM: - 5/8" or 16mm tubing aluminum ( probably could use steel too) Y-axis 500 mm = 400mm print area X-axis 440 mm = 300mm print area Z-axis 220 mm - 4 x 8mm linear rails Y-axis 500 mm X-axis 460 mm - 8 x 8mm linear bearings - 1 x RAMPS 1.4 - 1 x...
thingiverse
... The "H" cubes are connected with an H-shaped hinge that should be slightly flexible (don't print that hinge from PLA!) All cubes are easy to print without supports, they should be printed in any orientation where the hinges are on horizontal edges.
thingiverse
That face is compatible with EVA 2 mounts for all hotends that support universal face.You use a bunch of hotend supported by EVA 2 system (v6, mosquito, nova, rapido etc). For now I only upload the adapted face for X carriage. You can get direct...
prusaprinters
... or fixs.</p> <p>Hope it is useful for anyone. Probably I'll be the one to build an original hypercube in 2022 :) Print Settings Printer: Delta printer Rafts: No Supports: No Resolution: 0.2 Infill: 50 Notes: ABS Category: 3D Printer Extruders
cults3d
Hypercube is a mathematical representation of a cube in the fourth dimension (Known also as tesseract)
cults3d
3D version of the Reddit Alien (http://www.reddit.com/) 2*pi cm tall thinnest feature - antenna is just over 1mm thick 2 versions: solid and hollow hollow has 3mm wall thickness
thingiverse
3D version of the Reddit Alien (http://www.reddit.com/) 2*pi cm tall thinnest feature - antenna is just over 1mm thick 2 versions: solid and hollow hollow has 3mm wall thickness Instructions print the .STL with a 3D printer! license information: I...
thingiverse
[Reddit Request](https://www.reddit.com/r/3Drequests/comments/94ckxc/reproduce_stl_and_fixing_it/)