d20 mold 3d models
28948 3d models found related to d20 mold.thingiverse
this is a mold flask that you place your master d20 on the pedestal and pour silicone around it let it set then cut it open for a perfect resin mold
thingiverse
This is a D20 die mold. The resulting D20 rolls very well and has a nice bounce to it! It is made from syvwich's speed D20 design: http://www.thingiverse.com/thing:551 Instructions You will need: -5mm rods (bamboo skewers from the food store works...
cults3d
Much like my last mold, I used a 55mm d20, also known as an Icosahedron, to create the top and the base of the mold. Update 1: I re-arranged the hole made for the d20 to allow for easier removal. Update 2: Modified the top handle, sleeve, and...
thingiverse
Much like my last mold, I used a 55mm d20, also known as an Icosahedron, to create the top and the base of the mold. Update 1: I re-arranged the hole made for the d20 to allow for easier removal. Update 2: Modified the top handle, sleeve, and...
thingiverse
Mold of my D20 in case you prefer to make molds instead of printed parts.
cults3d
Mold of my D20 in case you prefer to make molds instead of printed parts.
cults3d
Cool mold to help you make custom d20 shaped bath bombs. The sleeve is needed for v1 and v2. ...You will have 3 models you need to print.
thingiverse
Basic snowball mold in the shape of 20-sided die (icosahedron). Print 2 each. ... UPDATE: 2022-02-06 changed alignment pin to conical.
thingiverse
after putting the mold back in and retaping, your going to mix and pour your silicone again and put the top with the label face down onto the silicone and put it into the pressure pot again. Take it out of pot and take apart carefully not to tear...
thingiverse
Designed to fit within a 4x4 Lego pip space. ...Used to make 2 piece molds of a single D20 die.
cults3d
This mold housing is perfect for making your own D20 dice (or a full set of DnD dice)! You can use it to make a two part silicone mold and cast your own dice in any color you like. The possibilities are endless! With this mold housing, you can make...
thingiverse
D20 for D & D of Magic the Gathering (Spindown) Standard supports + a 4mm brim. I normally print on 40 speed. The supports are easy to remove! ... I normally print anywhere between 40% - 60% but if you want a supersized die, print on 100% I...
thingiverse
D20 1.0 and 1.1 have rounded edges as opposed to the hard edges on 2.0 and 2.1 D20 1.1 and 2.1 have deeper etchings than 1.0 and 2.0 The font I selected is Microsoft's French Script, the the only thing I don't like about this font is that the 7...
thingiverse
d20_GoudyOldStile - d20 cube with old-style numbers (GoudyOldStile font)