dupont connections 3d models

This is a holder for standard size Dupont breadboard wires. ... The holes take a standard size 3.5mm self-tapping drywall screw.

If you print with plastic type PET-G then there will be no problems. Strength is more than enough What will happen to other types of plastics, I do not know. Please write in the comments your experience. I'll tell you a little hack on the print...

Need to print two to connect up to 4 resistors with dupont without soldering. ... Use it with Clip&Block https://www.thingiverse.com/thing:3344570

5mm Led holder for clip&block => https://www.thingiverse.com/thing:3344570 Used with IR led but it could work with any 5mm LED. ...Connected with dupont without any soldering

easy to print 0.2, 20% the v2 is flatest (bronze)

Secure your 4 wire dupont connection tightly. ...Prints fast without supports, maybe with some brim.

"Connections" likes are appreciated...

My work

... * Thanks to the remix source (<a href="https://www.thingiverse.com/thing:5188798" target="_blank" rel="noopener">https://www.thingiverse.com/thing:5188798</a>). &nbsp; &nbsp; 【Posted blog】 計測機器に接続するデュポンコネクタの脱落を防止するアダプターを作ってみました！ &nbsp; &nbsp;

pipe connections

Hinged connections

SMS connections

Keyed connections

Overhead connections

lock connections

Japanese connections

Some bolted connections (educational)

Joinery connections: splice

Joinery connections: tsarovy in one level

Surface connections - You can print as much as you like!

Diameter of connections for the tubes that interconnect the base: 20,54mm Diameter of connections for the tubes that interconnect the ceiling: 20,54mm PORTUGUÊS: Diâmetro das conexões para os tubos que interligam a base: 20,54mm Diâmetro das conexões...

The model consists of: 2 rectangular bases with central cavity where the pillars are fitted, 5 pairs of pillars - each pair with a different type of connection and 5 beams with different ends for the connections. The model has two functionalities:...

... ... pretty straight forwards, if you have questions please write them in the comments. Every piece is 17.5 mm * 17.5 mm with 3 mm more on each side with a connection, minus 0.5 mm all around for tolerance, which for me at least was more than plenty.

A customizable holder for dupont wires. Easy, but quite good. ... You can edit it to fit your own needs.

Hi, I create this Dupont holder so i can put them firmly together and i have a option to disconnect them easy. Maybe you can use this also. ...

Well another USB Dupont adapter, because most i've found were actually not fitting well and the USB Port was bent, can't be good for it... So i decided to make my own design. ... The Design is based on a 0.2 Layer Height, so 0.2 or 0.1 should be fine.

Needed something to hold Dupont connector together, so made this little coupler. underside is open so you can push them out that way avoiding too much strain on the cable. ... ...

STRUCTURAL CONNECTION

Clamp for further connections

Triangle corner drawer connections