hot end 3d models
168654 3d models found related to hot end.thingiverse
Hot End model. A direct modification of anode505's J-head model. 73mm tall 16 mm wide. The base lip is 2 mm thick. Print slowly or your printer may break it off the bed. ...It is almost solid, other than the 5mm hole through the middle.
thingiverse
The temperature measured at the end of the threaded M6 rod, stabilises at 46°C above the room temperature when the hot end is kept at 250°C. I had to set the temperature at 273°C in order to reach 250°C. But I used the distribution table for the...
thingiverse
Dimensionally accurate model of a Merlin Hot-End. ... Use it to create extruders or fanducts that use a Merlin Hot-End. I measured it myself from a Merlin Hot-End buyed at RepRapDiscount, with a digital caliper. ... Enjoy!
thingiverse
Made this convenient holster to store my hot ends when they aren't being used.
thingiverse
I wanted a more secure way of attaching the cable chain to the hot end of my printer. ...so i designed a part that will work with the bent part of the hot end
thingiverse
... a plastic model of a hot end? ... I wanted to have a model of a 3D-printer hot end for educational purposes in our Makerspace. I found the [CR-10 Hot End Model by intoxikated](https://www.thingiverse.com/thing:2920805), printed it and looked at it.
thingiverse
Now you can remove your hot end from your printer and place it into the “Hot End repair holder”. This holder also has the option of heating your hot end, so you can work on it in a hot state. This will come in handy for unclogging or assembly of...
cults3d
Now you can remove your hot end from your printer and place it into the “Hot End repair holder”. This holder also has the option of heating your hot end, so you can work on it in a hot state. This will come in handy for unclogging or assembly of...
thingiverse
These are two adaptor plates to turn a normal Repap with the extruder on the X-carriage into a two hot-end printer. The T shaped part fits where the hotend would. The large part bolts to the x-carrage and can hold two hot-ends. This thing was made...
thingiverse
This guide was created to assist and educate beginning and intermediate users with 3d printer hot ends by providing 1) Parts Identification 2) Correct parts placement 3) Correct disassembly and installation of the hot end. Failure to read,...
cults3d
This guide was created to assist and educate beginning and intermediate users with 3d printer hot ends by providing 1) Parts Identification 2) Correct parts placement 3) Correct disassembly and installation of the hot end. Failure to read,...
thingiverse
catch for hot end cables set. ... UPDATE: add lock part For 90 deg mainboard mount: https://www.thingiverse.com/thing:2845484