phone holder plane 3d models

I recently went on a plane trip and found some little phone clips. Looking at them, they're just some injection molded plastic, and unfortunately, one broke in my bag while I was loading my car. So, I fused the two pieces together with a lighter,...

... with a folded up magazine if needed (they're not all the same depth). I finally had the pleasure to try it out today and it worked great! It let me watch a movie without cranking my neck down to watch a phone that's balanced on the tray table.

A plane holder for planes without any gear. ...If you've got a plane with gear, see my other plane holder.

if you lost your Hotwheels plane holder, here you go

Take your writing to new heights with this pencil holder shaped like a plane.

This is a simple holder for woodworking router plane. ...I printed one from PETG, using 0.8 mm nozzle on Prusa MINI.</p><p>&nbsp;</p>

3-Piece Holder for RC Planes & Stuff. Small and Wide Version available. ...Please check alignment, my STL-Files are not aligned!

3-Piece Holder for RC Planes & Stuff. Small and Wide Version available. Please check alignment, my STL-Files are not aligned! ...Print Settings Printer: ZYYX 3D Printer ...

I needed a tool holder for my mini block plane. I could not find one here so I designed one using OpenScad. Why the cutouts in the front and back? ...Just to save some plastic and have shorter print time.

For safely storing the Bridge City HP-8 Mini block plane and the Stanley low angle block plane. ... https://www.youtube.com/watch?v=n2qJgELeJw0

... with 3mm walls and 2mm top and bottom, this ensures that any infill is actually done at the speed of the internal walls, and also creates a nice solid part. Tests show that my plane is now working as good as new, (it's actually about 40 years old)

This is replacement blade holder. My original had cracked in several places and been glued, but was never quite right afterwards. This model prints vertically, it needs support, but not much. In Cura I had to use 85 degree overhang angle and increase...

This is a remix of the very popular Paper Plane (https://www.thingiverse.com/thing:873630) I enjoyed the model, but wanted to have it rest on something other than my desk, so I designed this.

Designed and printed for my best friend who is a plane enthusiast. I remixed the nice Spitfire design to hold a M4 hexagonal nut, and designed a stand for it, so it can be used to hold a headset. ...Everything is designed to use 12 mm bolts with...

This part fits for the Hobbyking J3 Plane : http://www.hobbyking.com/hobbyking/store/uh_viewitem.asp?idproduct=33386 So the wingspan was 955mm. ... Instructions: For printing, it's porbably the best, if you use a support, so that the screw circle gets...

A little Wheel holder used to secure models during transportation or on the shelf. ... Designed with OpenSCAD, the source file is included to allow customization.

Phone holder to be printed 2 times one per side several angles available 50°;60°;70°;80 for phone 1.5cm thick modifiable on request do not hesitate to contact me if you see improvements to be made contains solidworks file and stl file phone holder to...

Phone holder Phone stand

Easy to print phone holder / phone stand

phone holder

holder phone

Phone Holder

phone holder

Phone Holder

Phone Holder

phone holder

PHONE HOLDER

Phone Holder

phone holder

Phone holder