picoaprs 3d models
12 3d models found related to picoaprs.thingiverse
Ein Ersatzgehäuse für den PicoAPRS V1, Das Glas kann vom alten Gehäuse wiederverwendet werden.
thingiverse
This is a big Batterie Case to the PicoAprs you can load and Expand battery capacity by mobil mobile operation. ... the plug is subsequently glued in with external filament.
thingiverse
This is a PicoAPRS holder for extrem APRS hamradio Print Settings Printer: prusa i3 Supports: Yes Resolution: 0.3
thingiverse
... my PicoAPRS vest clip. ...The first version had no provision for keeping the PicoAPRS in the clip. Version 2 has a tab with a ball to keep pressure on the PicoAPRS and prevent it from sliding out. ...Also cleaned up the cutout on the back of the clip.
thingiverse
This is holder with a clip to attach to a microphone loop on a safety vest or jacket. ...It is for the generation 3 of the PicoAPRS tracker.
thingiverse
This is a PicoAPRS V4 holder for biking APRS hamradio. ... No need support Printed in 0.3 Need screws M3 30mm long
thingiverse
... encloses the PicoAPRS box. The lid is attached with 2mm x 6mm screws. There are cutouts for the micro USB charging cable, an SMA to BNC adapter and/or SMA antenna, and a hole in the back to push the PicoAPRS box out of the case with a pencil.
myminifactory
Printed well in PLA at .2mm layer height with 15% infill and no supports.
thingiverse
Belt holder / bracket for PicoAPRS V4 hamradio APRS Transceiver. WARNING: Any liability for damage caused by the use of the bracket is excluded. ... This holder was designed by Tim Rauhut, DL2DMC