slammed rx7 3d models
1308 3d models found related to slammed rx7.thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=749887 Instructions Using the following options: wall = 3 do_shift_font = no fontname = Racing Sans One shift_font_percent = 0.07 base_radius_add_percent = .1 basethickness_percent = 0.1...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=749887 Instructions Using the following options: base_radius_add_percent = .1 do_shift_font = yes RoundedBase = 0 shift_font_percent = 0.07 textheight = 8 fontname = Sonsie One textsize = 25...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=749887 Instructions Using the following options: baseheight_percent = 1 textsize = 25 wall = 3 do_shift_font = yes base_radius_add_percent = .1 basethickness_percent = 0.1 fontname = Sigmar One...
thingiverse
Customized version of http://www.thingiverse.com/thing:74322 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=74322 Instructions Using the following options:...
thingiverse
Customized version of http://www.thingiverse.com/thing:52734 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=52734 Instructions Using the following options: font_size...
thingiverse
THE ORIGINAL SLAMMED SQUIRT By DroneCoProductions.com Join our "Slammed Squirters" facebook group to share your builds! 4x 25mm Standoffs required AIR UNIT MOUNT ONLY WORKS WITH 20x20 stacks The Old Tried And True Shendrones Squirt v2 With...
cults3d
Rx7 case, it is printed in o.3 since I did a post processing, but it can be printed in 0.2 0.1 for better finishing. In the future, when I'm making progress with the modeling, I'll upload it. ... It is approximately 30cm long.
thingiverse
This insta360 one R mount is ideally using a mount from the slammed squirt for a gopro9...
thingiverse
11mm slammed ducts and 9 mm mega super slammed ducts
thingiverse
slammed duct you will need 3 pcs m2 brass inserts to mount it on your icloud149
thingiverse
Camera key part to adapt a Micro sized FPV camera to the camera plates on a Slammed Alien frame.
thingiverse
Gopro Hero8 Mount for use with the Slammed Squirt. Printed in TPU. ... Compatible with Polar Pro ND Filter Mount.
thingiverse
... V2 Design. Thanks Chris! 4x 25mm standoffs 4x 20mm standoffs Squirt v1 and V2 have the same width between standoffs so the Vista Mount from the V2 Link will fit. Based Off: SLAMMED SQUIRT by DRONE CO - slammed squirt by DroneCOproductions