small wood shelf 3d models
322429 3d models found related to small wood shelf.sketchfab
Wood shelf Low Poly 3d model made in 3ds max 2016 Mantal Ray was used. ...Shelf itself : poly 4339 bolts (different object) : 169152
thingiverse
Small shelf, print upside down- flat surface of shelf to bed. ...shelf part need to be full material (set up bottom layer to 2mm)
thingiverse
Simple small shelf. ... I use it for my bicycle gloves :) -Update: v2: a bit stronger
thingiverse
Just a small shelf I made to display my golf figurines, it is approximately 8"X3"
thingiverse
A small shelf i designed :D i printed with 0.3mm layer height and 15% infill hang with command strips
thingiverse
A small Shelf to hold stuff like nail gels and other things to keep everything in order
thingiverse
... for my D-link router. ...I needed a small discrete shelf I could place high up on the basement wall. Since the router is quite light I could make a sleak design. ...I have mounted my shelf with the supports upwards to make it less visible on the wall.
cults3d
Small shelf wherever you want. ... Width: 18 cm Lenght: 11 cm Height: 7 cm Adding 100% infill around where screws will be can improve strength.
thingiverse
Needed a small shelf to store a few things so I threw this together. ...It has an opening on one side to slide items in and out.
thingiverse
Hello All, Remix of my small shelf for a PI, to hold filament. filament roller by filamentry, https://www.thingiverse.com/thing:2047554, cool design. ...Works well.
thingiverse
... objects (such as calibration prints). ... The deep shelf is deep enough for the Battle Benchy (https://www.thingiverse.com/thing:2765217), while the shallow shelf is the right size for a litter of Cali Dogs (https://www.thingiverse.com/thing:2781543).
thingiverse
A small shelf I made to mount to a wall without screwing into the wall you can use command strips or double-sided picture tape like I did. So far the shelves are holding up well without failure. ...Much of the success will be based on the mounting tape...
thingiverse
This is a Small 8x1x3/4 Shelf made to hold little figures. Screw Holes are like 1mm off. ... It's the first time I've ever used any 3d modeling software
thingiverse
I wanted a small, lightweight shelf to put spices on and a reason to practice using Blender. Countersunk screw holes. I wish I'd printed it better, haha. ... Should be scalable, remix away.
thingiverse
I built this small shelf to hold my Monster Bluetooth Speaker. This works great with my speaker... I'm sure you could put whatever you want on it. ...Sketchup file included.