split hose connector 3d models
111196 3d models found related to split hose connector.
thingiverse
... the parts together. The ring is glued at the backside of the adapter panel to give some (probably unnecessary) extra support. The hose connector is made to take any 152mm ventilation hose and use a hose clamp to attach the hose to the connector.
thingiverse
Someone asked if I could make a split connector. ...Well this was my first attempt.
thingiverse
Connector for hose 12/16mm in 8mm out 12mm out (bevel) 14mm hose holds very strongly
cults3d
It’s a connector. ...You can connect a faucet hose or watering hose for a 16mm diameter hose. ...It has holders for two o-rings for better sealing but can also work without them with simple clamps.
thingiverse
http://www.canadiantire.ca/en/pdp/yardworks-zinc-y-hose-connector-0593260p.html#.VxLJRTDA670 I got tired of securing it to my fence using brass u clamps. Simple design, lots of room to fasten and tighten hoses, etc. Openscad files are included. I...
thingiverse
Hose connector for a flower pot. Uses the typical o-ring found in household water taps in Germany. Two variants, one of them using the threads library: https://dkprojects.net/openscad-threads/ STL for hose ID = 10 mm, o-ring ID = 16 mm, OD = 23 mm,...
cults3d
Hose connector for a flower pot. Uses the typical o-ring found in household water taps in Germany. Two variants, one of them using the threads library: https://dkprojects.net/openscad-threads/ STL for hose ID = 10 mm, o-ring ID = 16 mm, OD = 23 mm,...
prusaprinters
Hose (barrel) connector for my flower pot. Uses the typical o-ring found in household water taps in Germany.Two variants, one of them using the threads library:https://dkprojects.net/openscad-threads/STL for hose ID = 10 mm, o-ring ID = 16 mm, OD =...
thingiverse
A connector I made to connect my large vacuum to my vacuum former (http://www.kickstarter.com/projects/kreation/kreation-vacuum-former-make-plastic-prototypes-and).
prusaprinters
If your gardenhose is too short or cut, this connector together with some hoseclamps and your ready to go! 13mm diameter
thingiverse
Simple connector for Turing Tumble split to fit most beds. Print two and glue together. Works great. ... Very cool of the Turing Tumble people to sell a "virtual pack" of the .stl's for the game and allow them to be shared.
thingiverse
The original Cyclopes_PTFE_Connector_Spacer was to big to fit my ender 5. ...I took this model and split it in two.