stl led lights 3d models
514147 3d models found related to stl led lights.thingiverse
I shortened the rail to fit on Ender 3 V2 (150mm) and support the wire guide. ... UPDATE: added a cover to just let the LEDs shine on the bed and hide them from front side
cults3d
Printing: 100% infill, 0.2 thickness and without supports NO COMMERCIALIZATION AND/OR DISTRIBUTION ALLOWED Complete GIANT alphabet (stl format) skate and destroy typography for posters with pixel led lighting: It is 25 letters (A-Z) corporate letters...
grabcad
based on the conceptually designed, deliberately designed mixed light, in which the LEDs with their radiation behavior, even with neighboring LEDs, produce a mixed-light scattered radiation.The planning of old LED developments is thus the basis for...
cults3d
This was designed to make lights for RC airplane wing tips. ... It works good for landing lights, RC cards, etc.
cults3d
Simple LED illumination of parts during printing Changelog * v1.1 - 2019-03-05: ** convert to Customizer ** add left wing of the ligts v1.0 - 2019-02-26: ** initial design
thingiverse
Simple LED illumination of parts during printing Changelog * v1.1 - 2019-03-05: ** convert to Customizer ** add left wing of the ligts * v1.0 - 2019-02-26: ** initial design
grabcad
I drew these because I design store fixtures and need to show lights on some of them. ...We use Inventor here.
pinshape
New files uploaded since the old housings where a little bit to small for fitting the LEDs inside.Print SettingsPrinter: GEEETech i3Rafts: Doesn't MatterSupports: NoResolution: 0.2Infill: 30% 3D HoneycombNotes: Running PLA, bed at 60C and extruder at...
thingiverse
The opening in the top cover is for the charge module and led.stl which transfers the charge indication lights (led.stl should be transparent) Parts used: * 5x 5mm blue LEDs * 5x 5mm red LEDs * 2x 18650 li-ion batteries * 1x on/off switch * 1x...
thingiverse
LED lights for Ultimaker. ...Needs 2 LED stripes from Ikea "Dioder" Instructions I printet it with 10% infill, 1mm shell/bottom/top thickness
thingiverse
These lights are designed for using COB LEDs such as these:http://www.ebay.com/itm/391318659309 EDIT! New files uploaded since the old housings where a little bit to small for fitting the LEDs inside. EDIT 2! New backpiece for easier mounting. Main...
grabcad
Single RGB led for cost effective traffic signal lights. ...the power source can be obtained through solar cells.