valu guide 3d models
68862 3d models found related to valu guide.
grabcad
Solus Valu-Guide Clamp piece # VG113-01. ... 2 pieces bolt together to make total holding unit.
thingiverse
Customized version of https://www.thingiverse.com/thing:45576 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=45576
thingiverse
Customized version of https://www.thingiverse.com/thing:739573 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=739573
thingiverse
Customized version of http://www.thingiverse.com/thing:739573 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=739573
sketchfab
A guide character modeled in Maya from a base mesh and textured in Substance Painter.
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=251470 Instructions Using the following options: frame_thickness = 7.5 filament_guide_wall_width = 3 arm_depth = 4 filament_guide_depth = 4 side = 0 inner_diameter = 15 arm_width = 8 guide_y =...
thingiverse
It goes in the bottom of the door to guide the flat locking bar into the hole in the cabinet door frame. Just pops into the rectangle hole in the door. May also be for upper bar. ... Dimensions: Outside: 19.4 wide x 7.1 deep x 13 Tall Inner Hole:...
thingiverse
Another filament guide, with cap. ... Put some double-sided tape under the guide to fix it on your table.
thingiverse
... I recommend a 2ft length. Instructions Slide it onto the protruding threaded rods on the top Slide in the filament guide tube Feed your filament through (There is no need to mount the tube onto your extruder, it stays put pretty well by itself)
cults3d
This tracing guide allows you to : draw the centre with a maximum width of 75mm draw lines at X mm from the edge
thingiverse
GUIDE CLEF - KEYS GUIDE Pour personne ayant des difficultés de préhension pour ouvrir ou fermer une porte, serrure Avantages : + meilleure prise + adapté à plusieurs clefs Nécessite un écrou et un boulon pour attacher la clef. ... Pour plus...
cults3d
Drill Guide for DCD796 Dewalt Screwdriver Drill or other with 49.3mm flange diameter You have to: 2 steel rods of 8mm diameter length 25cm 2 compression springs diameter 9.9mm length 70mm resolution: 0.2 infill: 25%. ... no support EDIT 29/04/19:...
thingiverse
A filament guide, that I use for my huxley. ...Its parametric, just change the value of radius in the scad file. ... Instructions just stick both parts together.