10 inch drill bit 3d models
548103 3d models found related to 10 inch drill bit.grabcad
10 inch Polycrystalline Diamond Compact Drill Bit Drill Soft & Hard Formation
grabcad
A model of a DRILL BIT with a diameter of 10 mm.A result of a modelling as near to an original drill bit, how I was able to implement it.It tooks a relative long time with many attempts (Trial And Error) to create a final model, which is worth for...
thingiverse
Just a simple drill bit holder for 1/4 in hex bits.
thingiverse
Simply put the bit into a hand drill and tighten it, then slip a few inches of the end of the strap through the gap and start winding it up. Start slowly and use the other hand to guide the strap to keep it aligned. Then just slide the rolled up...
thingiverse
This is a drill bit that accepts a 1/2 inch square socket driver and can hold a filament spool. This thing can be used to clamp down a spool to wind it full of filament with a cordless hand drill. Additional parts: ...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=91035 Instructions Using the following options: Drill_Bit_Length = 30 Resolution = 100 Set_Screw_Nut_Diameter = 5.5 Handle_Diameter = 25 Set_Screw_Diameter = 3 Drill_Bit_Diameter_Units = 1...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=91035 Instructions Using the following options: Set_Screw_Diameter = 3 Drill_Bit_Length = 30 Handle_Diameter = 25 Drill_Bit_Diameter_Units = 1 Set_Screw_Nut_Thickness = 3 Set_Screw_Nut_Diameter...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=91035 Instructions Using the following options: Drill_Bit_Diameter_Units = 1 Set_Screw_Nut_Thickness = 3 Set_Screw_Nut_Diameter = 5.5 Resolution = 100 Handle_Length = 65 Set_Screw_Diameter = 3...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=91035 Instructions Using the following options: Handle_Length = 65 Set_Screw_Nut_Thickness = 3 Number_of_Nut_Traps = 2 Drill_Bit_Length = 30 Set_Screw_Diameter = 3 Resolution = 100...
thingiverse
It's just a simple handle for drill bits 1 to 10 mm. ...two fixing bolt: M5 for reteining and M3 for fixing the bit.
thingiverse
A 3D printable jig I made to help me drill a straight hole for some floating shelves. ...It is also slightly off-center to accommodate for the [particular mounting hardware I...
grabcad
these are straight shank and tapper shank twist drill bits.There cutting angle or pointing angle is 138 degree and Taper shank drill bit is 10 mm in diameter where as straight shank one is 5 mm in diameter.