3d gyroscope

There's no comment needed. It's just as it is. No fuss, no muss. ...Nothing to add or subtract, just a simple statement of fact.

My First Attempt at Designing for Dual Extruders! Remember to Select Different Materials/Extruders for Each File! ...I Discovered a Larger Print for the Outer Cube of 55mm Plus, Which Suits This Design Better, Given That Wall Thickness is an Issue on...

Customized version of https://www.thingiverse.com/thing:1675026 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1675026

https://www.crunchlabs.com/products/build-box-subscription

IN THIS MODEL WE HAD CREATE SUCH TYPE OF VEHICLE WHICH CAN BE BALANCE BY ITS OWN

I love the original MEMS gyro, but it wasn't the right size of a wallet. Plus I found that the 0.5mm thin wall joints of vertical joints to be hard to print without gaps. So I used the 1mm joints throughout. ...Additionally I scaled it down vertically...

I optimized the original for **beer cans** which have a diameter of **67mm**. **The nut holders are for 7mm M4 nuts** (the original used a bigger not so common nut size). It still uses **M4 x 18mm** screws just like the original. I did not...

Replacement for RC helicopter rotors Inner ring diameter: 2,1mm length beween ring centres: 9mm The design relies on the first layer being slightly wider than rest of the print.

A colleague designed a Holder for the GY-91 Board for me. Here is the .STL. ATTENTION: Please measure the Holes! ...I am not sure if they are correct in this Version!