6 inch wafer 3d models
404305 3d models found related to 6 inch wafer.thingiverse
Inset for the mounting of two-inch wafers (sapphire, silicon, glass ...) in optical mirror mounts. ...Specifically, a sapphire wafer was glued into this part for use as a terahertz beamsplitter in a Newport 45 Degree Mirror Holder (MODEL: 9924).
thingiverse
This is a Display Stand for a 12 Inch (30 cm) Silicon Wafer I could print it in one piece on my 30x30cm print bed For smaller printers i did make a 2 piece version For printing orientation you need to make sure the "holding arms" are parallel to the...
youmagine
This is a wafer aligner made to fit 2, 3, and 4 inch wafers on a 45mm chuck. I have printed it in both PLA and PETG successfully. Cost savings is compared to a typical design is ~$1000. ...Depending on the material and infill settings, this part...
3docean
Model formats: - *.max (3ds Max 2008 scanline) - *.max (3ds Max 2008 vray) - *.fbx (Multi Format) - *.obj (Multi Format) - *.3ds (Multi Format) - *.mb (Maya 8.5) - *.lwo (Lightwave 6) - *.c4d (Cinema 4D 11) renders Are made in 3ds Max 2008 using...
thingiverse
This is a clam shell holder created for 1 inch, 2.5 and 3 inch. Created at AFRL (Air Force Research Lab) in Dayton, OH under the direction of the great Thaddeus J. ...Asel.
grabcad
Function:+ Wafer 4'', 6''+ Setup 2 inspect position+ Setup 4 carrier position+ Robot can move rotate and up-down, the robot is so smoothBest regards!