aero fin 3d models
13706 3d models found related to aero fin.
thingiverse
The fin is part of the landing gear, and therefore it has to be longer than the original (for ground clearance) and stiffer laterally to reduce wobbles on spoolup. You can modify the fin's size, angle, etc. ...to some extent by editing the parameters...
grabcad
The idea of using holes to reduce stresses. ...In this project, an aerodynamic fin shaped hole is used as a stress relieving feature which differs from circular holes used in the former one.
thingiverse
A simple dome/fin that will mount over a Ghost antenna mounted on the top plate and protect it from getting broken off. Also great for Freedom Spec to slip through the air with ease. ... Print at 100% infill for max weight increase to meet spec or go...
thingiverse
... but this works as is for a replacement. (ender 3-bed size 220x220) Original Fin = Standard_fin stl Spiked fin version 1 = Fin Spike #1 (Spiked fin version 2 = Fin Spike #2) Will try to add some more fins with a little extra flair in the future. ...
thingiverse
Small aero fin for mounting an SMA pigtail antenna to the Atto Sniper frame. ... Use a 2.5mm cable tie to secure it to through the slots in the top plate.
thingiverse
Need a fin for your model rocket? Look no further. ...Put it in your slicing software and turn it 90 degrees on the z-axis.
thingiverse
It gives more area to hold the fin, and works much better for fins attached above the bottom of the body tube. Putting both 3 and 4 fin slots made it too weak and easy to break. Just print whichever one you need. The extra slot is for motor...
thingiverse
When used with http://www.thingiverse.com/thing:345464 and 18" BT-50 tube, the center of pressure is just above the fin-can. via openrocket. No, not flown yet - but getting closer! [flown! see below] wt: 21 grams updated 6/22/2014: enlarged the...
grabcad
parts for scale models AS-463HB Standard Servo 3.95kg / 0.12sec / 45.5g XGD-11HMB Digital Servo - 3.0kg / 0.12sec / 11g TG9e Eco Micro Servo 1.5kg / 0.10sec / 9g
grabcad
This is my entry for the Blackboard Mobile Reader Challenge! I wanted to make something different, forgetting about box-type design! So I came out with an "out of the box" compact concept in which natural shapes flow, creating an ergonomic design as...