aerosol nozzle 3d models
71018 3d models found related to aerosol nozzle.thingiverse
A Aerosol Nozzle for Cooling Water from the Top, Air from the side Tested till 5bar airpressure and 2bar waterpressure makes very fine drops, which go more than 2 meters with that pressures
thingiverse
For this version you need a 3mm x 15mm screw and nut Update 8/11/18 The stock spray nozzle does not hold the straw very well so i took one off an air duster and it holds the straw much better. Currently eyeing a duster with the trigger closer to the...
thingiverse
This is a revision 2 for 2 axial 1/8" thread connectors
thingiverse
... Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=751540 Instructions Using the following options: line5 = made in Romania line4 = Prognosis line3 = MARIN line2 = SALIN line1 = AEROSOL
thingiverse
This adapts a 5mm air compressor blower nozzle to a 3.3mm aerosol can nozzle. It prints in less than 10 minutes and works seamlessly. ...Leave comments if you have a different size and want me to make it tailored to your needs.
thingiverse
2016-04-19 by Ezequiehttp://www.123dapp.com/creature/2016-04-19/5520383 Print Settings Printer: Alunar Rafts: No ...
thingiverse
Just an aerosol Holder. ... You can print top_aerosol.stl and down_aerosol.stl and join them with glue or just print one pice full_aerosol.stl
myminifactory
I created a very useful aerosol support with FreeCad.useful when you have to support the aerosol to do something else.
thingiverse
I put this together to automate some air fresheners, but you could fit this to pretty much any aerosol can and drive the servo however you want. Remote controlled air horn? Motion sensing Fart Spray? The rings on their own fit a 66mm...
prusaprinters
Have you ever dropped a spray can only for the nozzle to break off and render the can useless This was designed to snap onto a standard spray can to protect your aerosol nozzles from breaking off if it falls over.Let me know what you think and if I...