angle tester 3d models
87717 3d models found related to angle tester.thingiverse
For a Mars 2 (pixel width is 0.05mm) with a layer height of 0.05mm, this led me to a 45 degree angle supposedly being the best angle. However, I still had a lot of horizontal lines (Horizontal Lines). After being stubborn, I decided to do a little...
prusaprinters
I had questions about getting the correct angle to reduce the horizontal lines caused by pixel shift.We all know about arctan(layer height/pixelwidth) to find the ideal angle. For a Mars 2 (pixel width is 0.05mm) with a layer height of 0.05mm, this...
thingiverse
perfect for calibrating your 3d printer. this should be used on heated bed printers, so it sticks. when done printing, you can see if there are any inperfections. if so, calibrate the printer. (this is not an adult toy. ...some people might think so,...
thingiverse
Customized version of http://www.thingiverse.com/thing:58218 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=58218 Instructions Using the following options:...
thingiverse
This is a 22 sided polyhedral at 45 degree angles that can be used to test a handset at different angles relative to gravity.
thingiverse
I rotated this to Z-Up. I figured others may need it too. ...Some slicers can't rotate objects.
thingiverse
I was pretty impressed to see that I can get away with about 70 degrees of angle or archway! The part prints out in 5 to 90 degree slants in 5-degree increments. Level one is 5-45deg and should be no problem for any printer. Level 2 is 50-90deg......
thingiverse
The metal floppy drive screws I used for the tester fit tightly once a ran the tap in a few turns to ream out a bit, but access to the inside screw bosses is difficult so I just hit the first few turns carefully to get the screws started. The...
grabcad
The metal floppy drive screws I used for the tester fit tightly once a ran the tap in a few turns to ream out a bit, but access to the inside screw bosses is difficult so I just hit the first few turns carefully to get the screws started.The final...
thingiverse
Very simple support angle tester. One side is in 10 degree increments, the other is in 15 degree increments. Each angle is printed a full 3mm in the Z. Both 10 and 15 samples have offset and extruded samples, for examining wall thickness effect as...
cults3d
An angle, on the one hand to test how well your printer prints, on the other hand also for use after verification.
thingiverse
I made an angle to attach wooden tabletop to iron legs of a table. ...Print Settings Printer Brand: MakerBot Printer: ...
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=46838 Instructions Using the following options: x_holes = 3 hole_ratio = 1 round_corners = yes clearance = 0.1 shape = L_plate thickness = 2 y_holes = 2 cord_diameter = 1.5 screw_diameter = 10...