apc propellers 3d models

APC Propeller for hobby RC aircrafts - 14 x 8

I need a pusher propeller cover for my exist BLDC motor and 8x6 APC propeller. I just flip the CW propeller. ...If you have CCW propeller, you may need a mirroring and little modification.

REPLACEMENT APC FOLDING PROPELLER HUB

With this simple print you can use APC 10x4.5MR ST propeller with a 5mm shaft (M5 hex nut) instead of 6mm shaft (M6 hex nut). ...Link for the propeller...

This is a 40mm (center to center) propeller hub for APC folding propellers. The images include an example print with an 8x4 folding prop. The hub is designed for a 5mm motor shaft. Use nylok nuts to secure the M3 bolts used to fasten the two halves.

This is a 40mm (center to center) propeller hub for APC folding propellers. The images include an example print with an 8x4 folding prop. The hub is designed for a 5mm motor shaft. Use nylok nuts to secure the M3 bolts used to fasten the two halves.

Prop Adapter to use APC Propeller with T-Motor F40 Pro. The flanges of some props are so high it won't allow it to clear the top of the T-Motor. This adapter will help with that. Included are three sizes - 3MM, 5MM, 7MM. Use whatever is necessary for...

RC propeller, 3D scanned, fited with a surface.

precision modeled from scanned slices of the real propeller gpu-rendered in Bunkspeed Shot

R/C Model Propeller for Glow Engines, modeled from real propeller scanned slices. Very high precision. Suitable for CFD simulation and mold making. ...

This part allows the use of an airplane propeller, like the APC 6x4, in a drone motor like the E-max RS II-2600, with appropriate clearance. ...This is the case for the Reptile S800 wing The shaft hole is 5.1mm and the clearance provided is 1.5mm ...

Propellers

Propeller and Propeller cast

various propellers

Propellers, tools for dc motor.

both clockwise and anti-clockwise propellers

Propeller is designed by the help of Solidworks 2018

These are the propellers for my Science Showcase project.

This design would be good to print and then make a mold of so you could make lots of propellers for underwater robots or airplanes or similar. After printing a few versions, it appears that the props need to have a steeper angle for proper...

285th Scale / 6mm APC. It was briefly seen in some line art for Robotech / Macross. ...Model is attached to the base and designed so no supports are needed.

A low poly APC vehicle made for warzones and battles. Comes with high quality textures to appear higher poly than it is. ...Will run smoothly on mobile devices or AAA games.

Boomer APC

apc 4x4

colonial apc

windmill propellers

Boat propellers

rov propellers for sea perch

Military APC for army.

3 stl propeller 9*6 5,4,3,2 blades

I repeat apc is down.....