ar 15 bore guide 3d models
229239 3d models found related to ar 15 bore guide.grabcad
Useful tool for cleaning bore.Designed to print as one or two parts - for Z 210mm limited printers.
thingiverse
Bore guide and link pin for AR-15. Bore guide consists of two parts for easy printing on small printers. First part has one solid layer at the bottom for the easy bridge printing without supports, just cut out a hole when printing will be finished.
grabcad
This is an AR-15 bore flag. ...I printed it out of ABS, but NinjaFlex would probably work well also.
thingiverse
This is an AR-15 bore flag. ...I printed it out of ABS, but NinjaFlex would probably work well also.
thingiverse
Cleaning Rod Guide for AR-15 in 9mm Luger. ...This is for use with a rubber seal (15x21x2mm) on the front to prevent dirt/solvent from going to the lower.
grabcad
AR-15 assembly. Missing a few small parts like springs, but otherwise OK. All parts are mated appropriately. Modelled with SolidWorks 2012. ...And all parts are built with native features, not simply imported surfaces.
thingiverse
This is a 10-22 bore guide to protect you muzzle from damage when running a cleaning rod down the barrel. ...This was a modification of the barrel cap designed from imfurplay.
thingiverse
Bore guide to be used cleaning a Model 1894 Marlin rifle. Should be considered a beta/prototype. A bit of a tight fit when new, can easily be tapped into or out of the action. My first spin with AutoDesk 123D, so the part was modeled with a metric...
thingiverse
Keeps Cleaning Rod in Center Alignment & Protects The Bore Slip onto the cleaning rod before installing the brush or mop. ... 12 Gauge Bore
thingiverse
This is a muzzle guide to fit on the flash hider of a M14 or M1a rifle. ...It is designed to fit a Dewey .30 cal cleaning rod, and keep it centered to minimize contact with the crown.