atom proton neutron electron 3d models
40642 3d models found related to atom proton neutron electron.cults3d
The Electron is a housing for the electronics, extruder motor, and filament of the Neutron and Proton, the open source 3D printers designed by Layer One, the creator of Atom 3D Printers. Link to Proton:...
thingiverse
The Electron is a housing for the electronics, extruder motor, and filament of the Neutron and Proton, the open source 3D printers designed by Layer One, the creator of Atom 3D Printers. Link to Proton: http://www.thingiverse.com/thing:2149685 Link...
thingiverse
PART OF FULL PROTON PACK BUILD Pack: https://www.thingiverse.com/thing:2479141 This is the Neutron Thrower from my 3D printed Ghostbusters Proton Pack build. The prop was made using various measurements from the gbfans.com wiki. Changes were made...
thingiverse
This is a housing set for Mini 3DP Neutron/Proton for testing operation, or any Arduino Mega 2560 + RAMPS 1.4 + 360W industrial PSU combination. ... All available file format and related parts could be found here: https://a360.co/2JrXxcp
thingiverse
可以使用MK8擠出機彈簧(22mm x 7.5mm) using 22mm x 7.5mm spring(same as MK8 spring)
pinshape
This is a model of the electron transitions that occur in atoms, but represented in terms of a hydrogen atom. In a hydrogen atom, the single electron can "jump" to higher excited energy levels, but can also jump back down to the ground level of...
thingiverse
This is a patching solution for printed part, better to modified the original design to adapt Mega2560.
thingiverse
2018/7/16 update: shrink the M3 nut tunnesl to firm the nuts. ... ====================================================================== Add extended to 15mm M8 thread and chamfer some edges and widen some hole for easier assembly.
thingiverse
In particular, with 1 carbon atom, 4 oxygen atoms, 4 hydrogen atoms, 8 atomic bonds and 26 electrons can demonstrate the molecular change that takes place in the combustion between the methane and oxygen to obtain water and carbon dioxide. CH4 + 2 O2...
thingiverse
... You will need: - Each sphere half - 3x the wiggly line - Base - Pole (best printed in vase mode) Also check out the other models: Electron model: https://www.thingiverse.com/thing:4565698 Proton model: https://www.thingiverse.com/thing:4565686
thingiverse
this is just for my science project. ...I still need to add shells and electrons
sketchfab
Atom IFV Prototype for Russia in collaboration with France. ...Initially made for Arma3.