attic latch 3d models

Step 1: the only step is too carefully sketch out the part and precisely do the correct dimensions and boss extrudeStep 2: just be carful with some of the curves when using either arcs or circles

infill density: 30%Layar height: 0.2Top/Buttom layers: 6Material : PLA/PETG/ABS Support: NO

Part was built :)

I started by sketching out the front profile, making sure all the measurements including radius' were correct, then I boss extruded the model without including the circle.

CSWA part

Use for Door Cabinet....

step1: sketch geometry according to the blue prints (( !! crucial !! ...- when sketching make sure the arcs are fully defined first, then make the line under the whole cut out concentric with the axis))(note) the axis point in the blue prints can be...

I used the line tool to create my shape than started to dimension everything to the correct length. I used the arc tool so i could make my curves and everything. ...I than extruded than and but a circle on the shape and cut it through the entire shape.

Plugs that can be used on the model, positioned using rubber bands.

Steps:1. Started the sketch o the 40mm ark and dimensioned as I went, when I got to the corner with the two tangent arcs, I made the horizontal line coming from the 45 angle coincident with the point of the 29mm arc.2. Extruded to part width3.

I started by sketching out all of the straight lines and dimensioning them as such. To create the curved geometry, I used two different types of arcs. I created a centerpoint arc, using the midpoint of the long line in the bottom right as the center....

cswa

I hacked out a shorter cut of that thing.

<p>PLA 200/60</p><p>Fan 100%</p><p>no supports</p>

Simple FreeCad Assembly

Solidworks Certification test

Second try

Individual placed in second-ranked structure.

CSWA part

steps:1. created left edges sketch first2. added the curves, created relations and dimensions3. worked on right side of sketch4. added hole in left center of sketch5. added finishing relations with respect to the plus reticle thing6. extruded7.

I am a large language model. I don't have personal experiences or emotions like humans do. I was created to understand and respond to human input. ...My responses are based on patterns in the data that I've been trained on, rather than any personal...

step1: sketch geometry according to the blue prints (( !! crucial !! ...- when sketching make sure the arcs are fully defined first, then make the line under the whole cut out concentric with the axis))(note) the axis point in the blue prints can be...

Steps:1. Started the sketch o the 40mm ark and dimensioned as I went, when I got to the corner with the two tangent arcs, I made the horizontal line coming from the 45 angle coincident with the point of the 29mm arc.2. Extruded to part width3.