bear pen holder 3d models
422336 3d models found related to bear pen holder.thingiverse
Panda sitting by bamboo, where the bamboo is actually the pen holder. The panda needs supports, i used custom support, so simply added support for his right arm with the bamboo, then under his chin, his left hand and ear. that was it. ...
cults3d
Panda sitting by bamboo, where the bamboo is actually the pen holder. The panda needs supports, i used custom support, so simply added support for his right arm with the bamboo, then under his chin, his left hand and ear. ... that was it.
myminifactory
I put some holes in its back and turned it into a desk top pen holder. The holes are 15mm. I made them large enough to fit my fountain pens. I have printed this without support but it does not look nearly as good as with support. Turtleman...
thingiverse
This represents a modified version of the polar bear from "Polar Bear with Seal (automata)" https://www.thingiverse.com/thing:4052802
thingiverse
Bear Pencil/Pen Holder designed for larger pens and can be inserted cap side down.
thingiverse
Just a bear with eight holders for pens and markers, up to fine-point Sharpies.
cults3d
It is Teddy Bear phone stand! ...It is a Teddy Bear Bank! It is a Teddy Bear pen/pencil holder! It is all three! Make two in different colors and change out the sides for a two tone color combo. ... Prints flat.
thingiverse
Pen holder for Flying Bear Ghost 6 Two versions available: **Pen holder** (no supports) you need to remove the side panel of the printer to fix it. *(see the pictures below)* **Pen holder with open holes** (need supports) you just need to loosen...
thingiverse
This is useful for using a 3d printer like a plotter, just insert a pen in the hole. ... Do not scale it!
thingiverse
This is a simple remix of all of the revolver pen holders that are out there, but with a bearing printed in place for those who doesn't wont to take that much work. The bearing it's functional directly from the printer. I made it with enough...
thingiverse
Pencil holder with sliding bearing and spring. All in one construction. For Stepcraft CNC For Mitsubishi pencil Pna-125. Additionally you need a 3 mm bolt. ... Without supports, only two little support must cut after print, see picture.
thingiverse
Ball bearing supported pen holder to scratch pcb. The Idea is to scratch a layout on a coated pcb and etch afterwards. It is described by some other guy alreadyhttp://reprap.org/wiki/Scratch_n%27_Etch_PCBs. I have printed it but not jet tried to use...
cults3d
Made for bear fans. ...:) Depending on the printed size can use: -tealight holder -coin holder -key holder -candy holder -or anything that cames to mind :)