brillo pad holder 3d models
349710 3d models found related to brillo pad holder.thingiverse
A handy little holder for a brillo pad so that you can remove excess solder from your soldering tip with ease.
thingiverse
This is a holder for a Brillo Pad or similar sponge meant to be kept on a sink. I put holes in it to allow for excess water to drain. I designed this because leaving Brillo Pads on the sink can lead to rust. Print Settings Printer Brand: ...
thingiverse
This is a remix of the soldering iron stand by danekshea and the solder tip cleaner by diehart
thingiverse
... and patience on 8 revisions, for something so simple. Instructions Print, insert metallic brillo, either brass or copper. Do not use any pretreated pads with soap. Great source for these is Walgreens or the Dollar Store. ...Inclues OpenScad source.
thingiverse
Holder for brillo sponge / inox pad to keep your soldering iron tip clean. I made it a bit taller than needed, so you can put some metal nuts and bolts (or sand) in the bottom to give it some more weight against sliding around. ...(rubber feet will help...
prusaprinters
Holder for brillo sponge / inox pad to keep your soldering iron tip clean. I made it a bit taller than needed, so you can put some metal nuts and bolts (or sand) in the bottom to give it some more weight against sliding around. ...(rubber feet will help...
thingiverse
The original "Brillo pad for cleaning soldering iron" by wd73_ (2.6") I found too big, so I made two smaller versions with a 12mm solid base to add some weight to them. I first made the micro (1.73") and found it too small but still thought I'd share...
thingiverse
A part to fix a cotton pad holder to a wall Instructions As being fed up of our cotton pad holder standing around in the bathroom, I created a suspension to fix it on the wall. ...First fix the part to the wall, and finally the pad holder to the part.
thingiverse
Two types of stands for Senseo pad holder: Senseo-85 for pad holder with short and straight handles, Senseo-105 for the longer and angled version of pad holders.
thingiverse
Scouring Pad Holder. ... It´s a holder for 2 scouring pads. Easy to print. Low weight. Nozzle diameter, layer height, doesn´t matter. ... 117x117x52 mm.
thingiverse
Cotton Pad Holder - printable without supports - use high infill for strength