carnifex model

I printed [jessthemullet's][1] updated [Carnifex][2] which had the main body split into 4 parts with room for installing lights and magnets. However, I wanted to print a version that had a solid main body. I am printing on the Ender 3 V2, so the main...

They will fit both the Nidcronasaurus-fex and original GW Carnifex models (shown in the example included). There are two options available: A single gun arm which is complete, and a split version with one left and one right ready to print. ...After...

A Carnifex proxy model for epic has been netfabbed and is ready for deployment. Although it hasn't been test printed yet, its potential as a formidable opponent is undeniable. It's unlikely that additional poses will be added to this model, but one...

I think with a .2 nozzle, the print lines would be much less prevalent, but otherwise the original Carnifex model is a spectacular sculpt and prints beautifully. I did absolutely nothing for post print cleanup save remove the supports. Gave it a...

With a .2 nozzle, the print lines would be significantly reduced, but otherwise, the original Carnifex model is an exceptional sculpt and prints beautifully. I did nothing for post-print cleanup beyond removing the supports. A hasty paint job was...

Model

Models

Model

Model

model

model

Model

model

Model

model

Model

Model

Model

Model

model

Model

model

model

model

model

model

model

model

model

Model