cartoon turtle shell 3d models

Modified settings: PrusaSlicer > Print Settings > 0.20 QUALITY MK3 > Layers and perimeters• "Ensure vertical shell thickness: disabled" - I had problems with thin 45° hanging angles when it was enabled.• "Perimeters: 3" - infill pattern is less...

In this way, the outer shell serves as a kind of exoskeleton and keeps the part in shape, while the soft inside can dry and thus become firm again.Use a syringe or the funnel to inject about 3ml of IPA into the part:Then quickly hold the opening...

Modified settings: PrusaSlicer ► Print Settings ► 0.20 QUALITY MK3 ► Layers and perimeters• "Ensure vertical shell thickness: disabled" - I had problems with thin 45° hanging angles when it was enabled.• "Perimeters: 3" - infill pattern is less...

with a 0,50 width, set to 3 to have a 1,5 mm perimeters shells - First Layer Height: set to a value greater than 100% to have a first layer taller than Primary Layer Height and viceversa - First Layer Width: set to a value greater than 100% to have a...

I wanted the walls and areas around screws to be solid..2mm Layer Height4 Shells.4mm Line width5 bottom layers5 top layers20% InfillPrinted all the chain links together duplicated as a single print job. I printed a few extra just in case any had...

Modified settings: PrusaSlicer > Print Settings > 0.20 QUALITY MK3 > Layers and perimeters• "Ensure vertical shell thickness: disabled" - I had problems with thin 45° hanging angles when it was enabled.• "Perimeters: 6".• Seam position: Rear - I...

The planet of the homonymous Netflix cartoon (Centaurworld), this was based on the intro animation, and the space view from fourth episode. I scale it using the "glare" of the terminator line, assuming its sun it's a red dwarf (because it's seen...

I used a light green for the stem and leaves, and red for the pot. All parts were printed with the following parameters: 0.2mm layer height 2 outline shells 3 base layers 3-5 top layers 5-15% rectilinear infill Servo Preparation This projects...