cellphone stand 3d models
149639 3d models found related to cellphone stand.thingiverse
I needed a cellphone stand to use the phone with a bore scope or Butterfly iQ.
prusaprinters
Universal cellphone stand carefully designed by "Just Why Design". ...The design was created to fit into pocket od backpack and be used with any phone in any case.</p>
myminifactory
Simple stand for your cellphone. ...It containt 2 files, is the same objet but one has rounded cornerns.
thingiverse
Simple stand for your cellphone. ...It containt 2 files, is the same objet but one has rounded cornerns.
thingiverse
... 70/86=0.81, so in cura, you will put a uniform 81% scale. I used a 10mm brim when printed and generated a support for angles over 80. (My cellphone is 86mm width, 160mm height, 13mm depth) *Wires can pass under the stand since there is an angle*
thingiverse
... viewing experience while I'm sitting at my desk. This stand has a 9.5mm tray for holding phones and was originally designed to hold a Google Pixel 3 XL, though it will be able to easily hold phones that have a thickness less than or equal to 9mm.
cults3d
... viewing experience while I'm sitting at my desk. This stand has a 9.5mm tray for holding phones and was originally designed to hold a Google Pixel 3 XL, though it will be able to easily hold phones that have a thickness less than or equal to 9mm.
thingiverse
Also, the handle/support on the back enables mo to just pick it up when placing or receiving a call instead of having to pull the phone out of the stand, and use it as a phone handle. ...It could also be layered in colors for a cooler look, as shown on...
thingiverse
This is a phone stand with a charging chord that will go through the base and out the front or out the back this is helpfull if you want to keep a clean look onyour desk setup. I printed at 55mm per second and it took about 4.5 hours. Best of luck to...