cm4 3d models

Features: Capacity for 2 x 4010 fans Plenty of wiring space MCU and Pi CM4 Micro SD access (without having to disassemble or flip printer over) I/O panel access (without having to disassemble or flip printer over) Hi Airflow Fully Enclosed Honeycomb...

The parts are:PartAmountLengthWidthHeightSupportsEnginesPort112.7 cm6.3 cm10.4 cmBuildplate onlyEnginesMiddle112.7 cm8.6 cm10.4 cmBuildplate onlyEnginesStarbord112.7 cm6.3 cm10.4 cmBuildplate onlyCorridorDorsal116.8 cm16.8 cm4.8 cmBuildplate...

M2 hex bolts and heat set nuts - for Taco board M3 hex bolts and heat set nuts - for all other fixings Assembly: Put in all the heat-set nuts Fix CM4 module and heat sink to Taco board. Attach Taco Board to 'Lid' Attach HDD's/SSD's Attach HDD/SSD...

Since I'm using multiple Raspberry Pi CM4's and IO boards as NAS and docker hosts, I needed something to mount them on, other then the cardboard box they came in. So I made this simple backplate with standoffs that match the mounting holes on the...

All trays should allow for that.Print SettingsPrint face downNo supports needed.2 layer height.4 nozzlePerimeters 5 or 6 on the 1U shelf for strength (you want basically want it to be solid)Petg filamentPrintable Parts ListA left/middle/right 1u...

The bottom of the box has been lowered, so that the Pi (CB1, CM4) SD card slot is accessible from the outside under the fixing tab. The printer needs to be raised higher due to the lowered box and air filter. I made a remix from FONSWERKS Ender 3...

Since I'm using multiple Raspberry Pi CM4's and IO boards as NAS and docker hosts, I needed something to mount them on, other then the cardboard box they came in. So I made this simple backplate with standoffs that match the mounting holes on the...

 I had considered a CM4 module or finding someone to add an antenna connector to my Pi (there are people on Etsy that do it) but since it works, I'm just leaving it.I apologize, but the 3D models aren't super well constructed.  They're kind...