couch riser 3d models
11493 3d models found related to couch riser.
thingiverse
Just a simple riser for my couch from Ashley Furniture to allow my roomba to get under it and vacuum all the dog hair.
thingiverse
This Is A Versatile Furniture Riser.\nAccommodates Furniture Legs Of Up To 30 Mm Diameter,\nProviding An Easy-To-Use Solution For Home And Office Decor. Supports A Maximum Leg Size Of 30 Mm Diameter.\nThe Risers Raise The Surface Level By 30 Mm,...
myminifactory
... photos lol Roomba just started after I snapped them. We put some of those fabric pads on each corner of the print so it would be softer on our floors when moving the couch around but even before doing that these didn't scratch -- just sounded rough.
thingiverse
... corner of the print. These pads make a huge difference in preventing scratches and provide a softer ride for the couch as it glides across the floor. ...Even before adding the pads, these legs didn't scratch - they just made a slight scraping sound.
thingiverse
... sprang back to life. We also added some fabric pads to the corners of the print to make it gentler on our floors when we're moving the couch around. ...Even without these pads, this lift didn't scratch our floors at all; it just made a bit of noise.
thingiverse
Customized version of https://www.thingiverse.com/thing:49212 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=49212
thingiverse
this riser lifts your couch up 28 mm i needed my roomba to fit under my couch the hole is for the peg it is 30 mm in diameter.
thingiverse
... roomba. ...This is a very large print for a foot as the couch has feet that are 7.25" x 7.25". This will give the couch a 2" rise with a safety inset to keep the couch foot from sliding out. ... dimensions 7.25" x 7.25" x 2.5" 190 x 190 x 63.5
thingiverse
Adapted and modified to fit the legs on an IKEA Vimle couch/sofa... Mainly for a easy access for robot vacuum cleaner. ... Results in at least 10cm free height This is a remix from https://www.thingiverse.com/thing:761196
thingiverse
now my roborock S7 can clean anywhere. ... I used 12% infill, its ok atleast when couch is against wall so foots are not strained sideways. ... also redrilled holes with 8mm bit.
thingiverse
... mine in PLA using three layers on top and bottom, a layer height of 0.20 mm, and 20 percent infill. Depending on the weight and number of legs on your furniture, you may need more infill than I used on my couch, which had an impressive ten legs!
thingiverse
Customized version of https://www.thingiverse.com/thing:49212 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=49212
thingiverse
I created this product after failing to find a suitable solution on Amazon or Thingiverse. My goal was to develop a device that would lift furniture with a base no larger than 1-5/8 inches, preventing my Roomba from getting stuck. ...These pucks raise...
thingiverse
While there are some barriers along the border of this section that might prevent cleaning in certain areas, the entire underside of the couch should still be accessible for cleaning purposes. To extend the threads on the original legs, I used...
thingiverse
Customized version of https://www.thingiverse.com/thing:4088666 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=4088666