crayon sharpener 3d models
4897 3d models found related to crayon sharpener.
thingiverse
You'll want to use some sandpaper on the sharpener's face to create a razor-sharp edge. ...I opted for 240-grit sandpaper and encountered zero issues.
thingiverse
This crayon sharpener is designed for larger crayons, though smaller ones may fit too. Printed using MakerBot 2, it requires correct orientation and no supports. Infill is set at 10% with two shells and a 0.3mm layer height. It uses a standard razor...
thingiverse
My daughter uses these Crayola Jumbo crayons, but they turn into 3 inch long dull sticks with no great way to sharpen them, so I made this. It was inspired by https://www.thingiverse.com/thing:273589, but increasing the size and effectiveness...
prusaprinters
While Prismacolor make a special short-point sharpener for their pencil-crayons, it's rather expensive and not always reliable. It uses roughly the same sharpening angle as jumbo pencils, and companies such as Staedtler and KUM make good quality...
thingiverse
While Prismacolor makes a special short-point sharpener for their pencil-crayons, it's rather expensive and not always reliable. It uses roughly the same sharpening angle as jumbo pencils, and companies such as Staedtler and KUM make good quality...
thingiverse
Poignée pour taille crayon, pour l'assembage une vis tête fraisé et un écrou M4 sont nécessaires. ... Handle for pencil sharpener, a countersunk head screw and M4 nut are required for assembly.
thingiverse
Instructions with photos detail the process: first, choose values, render, print, and note plaster volume; second, coat mold surfaces with a release agent and pour Plaster of Paris; third, cut sprues, remove mold, and fill with melted crayons; for...
thingiverse
From now on, no more issues with the stability of your pencil sharpener due to this innovative design, this component is specifically designed to be attached to a corner of a desk and it stays put from then on.
thingiverse
Bonjour, pour sauver un taille crayon bulldog d'époque, j'ai refait la partie plastique qui sert de couvercle et de réservoir. Traitement à l'acétone, mastic, apprêt, ponçage, peinture, ponçage, peinture, ponçage, peinture. ... Hi, rebuilt the plastic...
grabcad
Not originating from Trinity, this information may be shared without her permission; however, upon her request, I will swiftly remove it.