danbots 3d models

This makes your Polaroid cube compatible with some of the gopro mounts. ...I modified DanBots mount to make the Polaroid cube part.

... Polaroid Cube Mount to fit my handlebar which is 24mm in diameter (0,94 inch). ... I also removed the magnet hole and made the walls for the tie raps a bit thicker compared to the other cycle mount by Danbot. ... Have fun and use at your own risk!

Modified from a great little holder, by @DanBot, that fits around an iPhone (US) charger block, and holds your device cleanly against the wall. With some break-thrus, now it's good for most iPhone generations. By some add-ons, it organizes chargers...

Also put the hole back in it from Danbot's design. http://www.thingiverse.com/thing:616846 Moved the hole to center the camera magnet. Customized with CUBE on the back. Also included a plug for the hole if don't want to use the magnets. 10mm x 6mm or...

The design is remixed and inspired from two designs on thingiverse:- Galaxy S2 wall mount by NilsRoe (http://www.thingiverse.com/thing:120665)- iPhone Wall Plug Holder by DanBot (http://www.thingiverse.com/thing:92946)Printed on Ultimaker2  Sliced...

It is based on user's "DanBot" design (www.thingiverse.com/thing:279143). I have just carefully spliced it two and lay it flat so it can be printed. I've added a folding tab on the cyclist's back and added 3 holes so it can be glued in place with...

It is based on user's "DanBot" design (www.thingiverse.com/thing:279143).I have just carefully spliced it two and lay it flat so it can be printed. ...I've added a folding tab on the cyclist's back and added 3 holes so it can be glued in place with...