dango wallet 3d models
4079 3d models found related to dango wallet.
cults3d
Alternative to bifold wallet, this card slot allows storage for additional 4-5 cards. Both standard and tighter fit files included. Personally I prefer the tighter fit. ...Standard fit is similar to the bifold wallet.
thingiverse
Need 2 10x1.5mm round magnet. ... Use glue to glue magnet into the clip, and just slide in the holder into to slot on the wallet.
prusaprinters
It's a pullout tray for the pen pocket hole in the Dango bifold pen wallet.Extra Materials Needed:2 4mm x 1mm magnets1 4mm x 3mm magnetsYou'll need to superglue the anchor to the magnet end of the tray and the endcap to the other end. ...I had to shave...
thingiverse
Dango, dango, dango, dango, dango daikazoku! After looking around on Thingiverse for a Clannad Dango Daikazoku model, I was left unimpressed. ...So, armed with my limited ability in modeling and Autodesk Inventor, I got to modeling this perfect treat.
pinshape
Summary Dango, dango, dango, dango, dango daikazoku! After looking around on Thingiverse for a Clannad Dango Daikazoku model, I was left unimpressed. ...So, armed with my limited ability in modeling and Autodesk Inventor, I got to modeling this perfect...
thingiverse
A Dango from the Anime "Clannad" and "Clannad After Story" Print it with slow settings and small levels, that way you can print pretty clean and without support. ...Maybe some filing and painting afterwards improves the result.
thingiverse
You can upscale without issues, but downscaling might make the bunny dango's face less noticeable. I printed mine whole, but you may want to print them in parts and then sand them down + paint them separately before super glueing them together...
thingiverse
I printed an infill for my dango wide capsule to fit Euro-coins as the coin holder is only available for us-coins. It fits 9 2 Euro, 9 1 Euro and 8-9 50 cent coins. ... As you can see in the picture, the design does not fully close, but I don't care as...
cults3d
Bear Dango is so cute! You can decorate and play! Textures/uv map not included. The model is sculpted as a single piece: not MMU. You are not allowed to share, distribute and sell the downloaded files. Non-commercial licence. ... Follow us: ...
cgtrader
Dango Vases by Shizue Imai | 3d model produced by Design Connected | www.designconnected.com This 3d model is part of the highly acclaimed Design Connected collection featuring 6500+ carefully picked exclusive furnishings. Check out our full range of...