db9 rs232 3d models
544 3d models found related to db9 rs232.
prusaprinters
Also exposed the jumpers by the DB9 connector. Case PCB to sidewall gap reduced to 1mm from 2mm for a snugger fit, and the clip pins tweaked for better fit too. Added version 2 of the 1.6mm shell with snap fit clips, the PCB pins now just hold it in...
thingiverse
As a probe for the board surface sensor, the most common antenna from a radio receiver with a screw thread at its base is used, which can be bought at any radio store the project of vacuum tweezers "NATASHA-1" will not be described in this article,...
thingiverse
### Notable Autostar configuration parameters Telescope - 4504/114EQ if FW patched, otherwise DS-127 Alt/Dec Ratio = -03.28533 (1:144 worm ratio) Az/RA Ratio = +03.28533 (1:144 worm ratio) Alt/Dec Percent = 75% Az/RA Percent = 75% ### Parts list 2x...
prusaprinters
The controller was blocking the RS232 communication and Octoprint diconnected due to timeout. I have updated the arduino-script to version v0.2. This should solve the issue - at least it does with my machine! I also updated the file with source-code...