diatone gtr349 3d models
1770 3d models found related to diatone gtr349.thingiverse
A Canopy for the Diatone GTR349 with added Mount for Caddx Vista Antenna + RX Antennas
thingiverse
Made it slightly longer in Tinkercad to fit the Diatone GTR349 and have the GPS and cable stay out of the way of the capacitor and power cable. Printed in TPU. Used doublesided tape to fix the GPS to the mount. It's 2 gram, printed without supports...
thingiverse
The original design was a little rough around the edges and the fin wasn't quite tall enough.I also had issues with the front bumper not being attached. There's also some upgrades, I beefed up and extended the camera protection, added captive nuts...
thingiverse
Diatone 2019 GTR349 Arm Protector. I don't care for the ones where the arm protector are held on by the motor screws. I made these to slip on and one zip tie to hold them on with. Offering three versions. no screw holes, driver size holes and full...
thingiverse
Diatone 2019 GTR349 VIFLY Finder 2 mount. this mount will likely fit on GTR249 or any Diatone that uses the same canopy. the beeper fits tight you don't have to use a zip tie but I did design it the help support the mount by running the zip tie...
thingiverse
For Diatone ET 160 - Design by Diatone.Karl Frame with new 25 mm Spacers available here: http://www.banggood.com/Diatone-ET-160-V1_0-Carbon-Fiber-Quadcopter-Frame-Kit-w-BEC-Power-Distribution-Board-p-995923.html?p=HP210612749272015022
thingiverse
Xt30 mount for diatone grasshopper g160, cutout for vtx antenna