drain plug adapter 3d models

A small adapter for BMW motorcycle drain plug. ... Un petit adaptateur pour bouchon de vidange de moto BMW.

This is meant to be an adapter to allow 1/2 tubing to connect to the drain hole of ORCA coolers. There are 3 designs to accommodate 3 main discharge angles based on where the threads bottomed out on my cooler. ... Make sure to evaluate this based on...

My car has a drain plug of 6mm knob, instead of using a philip screw. The other end can accept a 17mm hex socket This thing was made with Tinkercad. ...Edit it online https://www.tinkercad.com/things/fHX0WbBLG1T

Here is a yeti drain hole Hose adapter. Didnt want to spend the 13 dollars on the website. On my boat, I like to drain my Yeti Tundra over the edge but sometimes its gets very heavy with melted ice and left over drinks. ...Just attach a hose and run it...

I had a previously installed [drain kit](https://www.chriscoffee.com/Drain-Kit-Vetrano-p/vdrkt.htm) for my Quick Mill espresso machine but needed to upgrade to the [new drain style](https://i.imgur.com/9hk8Rbk.png). I remixed this excellent design...

I had a previously installed drain kit for my Quick Mill espresso machine but needed to upgrade to the new drain style. I remixed this excellent design to add inner threads so I could screw it on.</p> <p>I printed it in ABS due to the hot water it...

This is an adapter for connecting a 32mm intex hose to [this](https://www.thingiverse.com/thing:4687655) drain plug. Use teflon to seal the thread. ...

G3/8 thread to 10mm barb to screw into the EKWB EK-AF FillPort drain plug and attach a hose to either fill or drain your loop. ... I sliced it at 0.1 and printed using cura defaults.

Bathtub drain plug

drain plug. ...I used it as a drain plug on a boat

my drain plug broke, so I made a replacement

Tub drain plug I made, should be printed without supports and with flexible filaments.

... one of the sinks doesn't have a plug in it. ...That wasn't a big deal since I don't usually fill my sink, but then I dropped something down it, so this item is partially aesthetic and partially just to prevent small items from falling down the drain.

My bathtub didn't have a way to efficiently filter hair, so I made this to stop hair and stuff from clogging the drain.

A simple adapter for allowing both washer and dryer to be connected to the same drain pipe..

Drain fitting with plug

Drain plug replacement

Drain plug for jetskis

A standard drain plug screw :)

Part of a sink drain, you need a rubber gasket, or put silicone at the junction with the sink.

Drain plug for a Yamaha waverunner.

made for Quest Kayak drain plug. threads didn't print too great but definitely works. dont go too low on layer height. maybe keep it around 0.2 mm. ... I always print functional parts at 100% fill and ABS

Surface pump drain plug. ...ISO pipe thread size 16.662mm.

Drain plug for the Seadoo Challenger 2000 boat

Simple drain plug. Print in nylon. ...It works properly.

AB dinghy drain plug. ...M20x2.5 ISO Metric thread profile.

Replacement drain plug for coleman cooler. ...Print upside down.

Simple tool to make turning radiator drain plug easier.

This is just a simple holder for a Boat Drain Plug. ... Fit's 1" Drain Plugs and mounts with 2 screws.

This is just a simple holder for a Boat Drain Plug. ... Fit's 1" Drain Plugs and mounts with 2 screws.