ear lug 3d models
59400 3d models found related to ear lug.thingiverse
This is 50mm diameter backplate, which I made for my Mitutoyo 2046S dial indicator. ...It probably fit on other models of Mitutoyo (check dimensions on last image). I add fillet around lug to prevent cracks of filament in this area.
thingiverse
Lifting Lug I designed for a FEA (Finite Element Analysis) class. It is a lifting lug used to lift large shipping containers. ...I included a x_t (parasolid) model for direct use in ANSYS.
thingiverse
... Instructions The idea is to build a 3D printed bamboo bike. ...Bamboo bikes involve lot of manual labor and a jig. If all the lugs are printed and then reinforced then the manufacturing would be much easier.
thingiverse
... the Bosch Battery Charger wall mount: https://www.thingiverse.com/thing:4567482. By designing a mount based around this lug you can attach anything to a pegboard! My pegboard uses 4mm holes. ...I'm sure this thing could be adapted to any board.
grabcad
I am not very experienced using Inventor (I try..), but here is our 'older' design of our Lug Tipper. Since this design some changes/improvements have been made, but this version still represents the basics (only) of the tipper. Not shown on this...
thingiverse
Designed these lugs to fit the existing lid holes to lock the lid in place and to help keep the tie-down straps from slipping. survived a 1000 mile trip through heat, rain and snow. not bad for simple PLA. Print Settings Printer: ...