earphone cable 3d models
95760 3d models found related to earphone cable.thingiverse
Fishbone earphone cable organizer for 3,5mm jack or iPhone.
thingiverse
This is a simple thing that clips permanently onto a earphone cable, and allows winding the cable tidy when not in use.
thingiverse
Just a short though of earphone cable holder in an hour. ...Haven't tested in print yet Let me know if it works fine :)
thingiverse
After a few weeks using the Wishbone based earphone cable organizer ( http://www.thingiverse.com/thing:31053 ) I decided to tackle a redesign to eliminate some of the problems. With the original design the cables would sometimes pop out of the end...
myminifactory
Whether you're listening to your music on your mobile device while commuting to/from work, out for a run or at the gym you really don't want your Earphone cable flying round, which is a nuisance, and is a safety risk because it may catch on things...
cults3d
Whether you're listening to your music on your mobile device while commuting to/from work, out for a run or at the gym you really don't want your Earphone cable flying round, which is a nuisance, and is a safety risk because it may catch on things...
cults3d
Fun design that lets you wrap your earphone or cable nicely. NO more tangled cables! Some of the ear buds may have different sizes, the current model have hole size of 20mm, measure and scale before you print! Leave a comment on what you would like...
myminifactory
Fun design that lets you wrap your earphone or cable nicely.NO more tangled cables!Some of the ear buds may have different sizes, the current model have hole size of 20mm, measure and scale before you print! Leave a comment on what you would like to...
thingiverse
Fun design that lets you wrap your earphone or cable nicely. NO more tangled cables! Some of the ear buds may have different sizes, the current model have hole size of 20mm, measure and scale before you print! Leave a comment on what you would like...
pinshape
Fun design that lets you wrap your earphone or cable nicely. NO more tangled cables! Some of the ear buds may have different sizes, the current model have hole size of 20mm, measure and scale before you print! Leave a comment on what you would like...
thingiverse
a simple earphone holder to arrange the wire. use it to wind the wire in an “Eighth loop”, put the top and the end of the wire into a gap. This way, the wire won’t be twisted as if if it lay flat on the ground. there are four gaps, so it should...
thingiverse
tinny cable ring with little lock to organize cable in my pocket. ... 1,75 mm filament as a pin/axis
prusaprinters
122x62x13 mm width of the wire holder: 10,4 mm Print Settings Rafts: Yes Supports: NoResolution: 0.1 mm Infill: 40% Filament: any PLA any Notes: a simple earphone holder to arrange the wire. use it to wind the wire in an “Eighth loop”, put the...