easyglider pro 3d models

This Design is a Solid Start for the Glider Pro Canopy, Though It's Far from Flawless - I'm Already Planning to Refine It Further. At This Point, It Covers the Glider by About Ninety Percent, Leaving Room for Some Additional Work. ... I've...

Humans depend on printing information retrieved from Automatic Binding Systems (ABS) to manage essential business operations effectively daily now.

* EasyGlider_Canopy_N0.stl * EasyGlider_Canopy_N1.stl * EasyGlider_Canopy_N2.stl * EasyGlider_Canopy_N3.stl * EasyGlider_Canopy_N4.stl ### Nose Parts ### The following list contains the 2 files that I used in order to replace the first part of the...

I lost the Conopy of my MPX Easyglider 4, now i print a new one.

The new human design serves as a reliable substitute for the original easyglider fuselage system. ...It's not flawless, yet it functions effectively.

A clip to put on the old clip to close the plane. ...you just have to cut the older one.

A simple tool to secure the aircraft in place - just replace the worn-out clip by cutting it off.

This is a remplacement part for the plastic on the Multiplex EasyGlider (Pro, Blue) that holds the Cockpit in place and keeps it from falling off. It's not perfect, the glue tabs on the bottom are a little far apart, but you can just pressfit them...

simple skids to protect the bottom of your precious Easyglider Print them with 0 infill and two perimeters. ... Hot glue under the wings.

Ich habe das Transportsystem von "Pizzamampf" genommen und für meine Bedürfnisse angepasst. Als Griff habe ich einen von "guppyk" verwendet. Die Verschlüsse oben habe ich nicht mehr benötigt, da die Flügel sehr passgenau sind und dadurch bei...

Smile freely, I'll format as desired :). ...Me was printed using PLA, with layers at 0.2mm and a 50% infill, all without the need for any supporting structures.

Print how ever you want to print ;-) Me printed in PLA, 0.2Layer & 50% infill with no support.

So i decided (after some hard landings and deformed nose) to cut off the nose behind the motor, convert the easyglider to a 2-engine-FPV-Trainer: Nose replacement with internal Cam-Holder Cam: 22,5mm x 22.5mm case and 17.5mm diameter lense Wing...

Update 25-JUN-2017 Feature "Customizer" reactivated (working again for whatever reason) Update 16-MAY-2016: Optional slot added in sawtooth area for reduced weight and improved adhesion Chamfers in tip section optimized for better print results...

Installing the battery of EsayGlider is critical to insure godd balance of the plane (CG position). Multiplex rproposes to use "Velcro" tape to fix the battery into the fuselage. This is not simple neither efficient... I have designed this...

Pro

Duskull Pro+

iPad Pro

iPad Pro

PRO V4

Mac pro

iPhone 12 Pro & AirPods Pro

HI PRO Medal

Genius Pro Slot Covers

HI PRO Medal

Customized version of https://www.thingiverse.com/thing:1672381 Created with Customizer! ...https://www.thingiverse.com/apps/customizer/run?thing_id=1672381