feiyu mg v2 3d models
98983 3d models found related to feiyu mg v2.thingiverse
Adapter to use the Xiaomi Yi on immersionRC Xugong v2 or feiyu tech g3 gimbal. ...Print Settings Resolution: 0,2 Infill: ...
thingiverse
HiTech HS-645 MG Servo Saver_V2 Print Setup: - Layer High : 0.15mm - Speed : 60mm/s - Infill : 100 % - PETG *edit*12.03.2020 The safer has been slightly revised. ... But the pictures are still the old ones.
thingiverse
... of http://www.thingiverse.com/thing:46825 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=46825 Instructions Using the following options: hoehe = 20 textshow = MG laenge = 35 textsize = 10 rad = 30 make_holder = 1
thingiverse
http://www.thingiverse.com/apps/customizer/run?thing_id=114247 Instructions Using the following options: pin_cap_width = 4 ring_height = 6 center_radius = 12 pin_radius = 2.45 Build_Plate_Manual_Length = 100 pin_hole_radius = 3 pin_cap_gap = .45...
thingiverse
A while back I made a model of the base weapon used to create the RT-97c blaster as seen in Star Wars: A New Hope (and many other places since!) I was pretty new to OnShape / 3D modeling / printing, and did a lot of things differently than I would...
cults3d
A while back I made a model of the base weapon used to create the RT-97c blaster as seen in Star Wars: A New Hope (and many other places since!) I was pretty new to OnShape / 3D modeling / printing, and did a lot of things differently than I would...
thingiverse
This is for the person who lost the Feiyu G4S Gimbal holder. ... I recommend you to print V2
thingiverse
Revised mount for the Feiyu Wearable Gimbal. ...Use M6 hardware to complete the build.
thingiverse
Small GoPro to feiyu mount. ...3h of printing. Add a ziptight to proof it. Print Settings Supports: Yes Resolution: 0.2mm Infill: 100% Notes: Small GoPro to feiyu mount. 3h of printing. ...Add a ziptight to proof it.
thingiverse
It's design for Feiyu Gimbal. ...Diameter of outer hole = 8 mm Print Settings Printer: Creality CR-8 Rafts: No ...
myminifactory
This is a mount for the Feiyu Wearable Gimbal. Use M6 screws to mount the handle. ...I recommend the handle to be covered in foam handle / bmx handle / be creative here with what's on hand.
thingiverse
GoPro Gimbal Feiyu-Tech FY-G3 Ultra 3-Axis Gimbal with GoPro Hero 3. ... Thank you Jimano for the GoPro SketchUp model I used to put in the mount.https://3dwarehouse.sketchup.com/user.html?id=1330948307652934184763176
thingiverse
Two different clips to mount two cables, each up to 5mm to your Feiyu A2000 gimbal. The pitch and roll arm have different sizes. In my case an HDMI cable and an external power supply for the camera. Directly from your printer to the gimbal. No need...