fileted 3d models
2830 3d models found related to fileted.thingiverse
I have been working on 3D printing a steam (OK, It will run on air) engine and I found that I was in want of a concave filet so I decided to write a few modules to create some.
thingiverse
Plain Shelf fileted Bracket I haven't test printed this yet Please post photos
thingiverse
4 point vase fileted I have not test printed this yet Good luck Please post a photoThanks
cults3d
4 point vase fileted I have not test printed this yet Good luck Please post a photoThanks
cults3d
Straight Vase Fileted edge I have not test printed this yet Good luck Please post a photoThanks
thingiverse
Straight Vase Fileted edge I have not test printed this yet Good luck Please post a photoThanks
thingiverse
it has six walls and eight walls so it's an octo-hexta-hedron fileted. ...This is the last of my collection of 3D geometrical shapes
cults3d
Square Circle Vase fileted 1 I have not test printed this yet Good luck Please post a photoThanks
thingiverse
Square fileted Vase with Hole I have not test printed this yet Good luck Please post a photoThanks
thingiverse
Square Circle Vase fileted 1 I have not test printed this yet Good luck Please post a photoThanks
cults3d
Square fileted Vase with Hole I have not test printed this yet Good luck Please post a photoThanks
thingiverse
Square Jug with Fileted corners I have not test printed this yet Good luck Please post a photoThanks
thingiverse
Vase v 360 twisted fileted I have not test printed this yet Please post photos Thank you
cults3d
Vase v 360 twisted fileted I have not test printed this yet Please post photos Thank you
cults3d
Square Jug with Fileted corners I have not test printed this yet Good luck Please post a photoThanks
thingiverse
Square Circle Vase fileted 2 I have not test printed this yet Good luck Please post a photoThanks
thingiverse
... it fit correctly in the X carriage better. ...I also did a filet on the clamp for the heatsink because the original was just a bit hard to install. Now it may be slightly too loose. ...You can wet sand the sides and mating surface for a better fit.
thingiverse
Customized version of http://www.thingiverse.com/thing:788599 Created with Customizer! ...http://www.thingiverse.com/apps/customizer/run?thing_id=788599 Instructions Using the following options: nbr =...