fishing rod belt holder 3d models
424745 3d models found related to fishing rod belt holder.
thingiverse
Printed in ABS and PLA which came out very solid with 0.8mm nozzle and 0.6mm layer height. ... Once I take it out fishing I will share more photos. Please share your makes and tight lines! ...
thingiverse
[Roman Dontsis](https://www.thingiverse.com/ROAMN) uploaded fishing rod holders for vertical and diagonal belts, which were not suitable for my setup. ...I tried to modify them accordingly, but due to lack of skill, I decided to design my own,...
cults3d
(This Version is the older version and has a larger belt opening. Ball Joint version: No support needed. Add a screw in the middle to strengthen the bar so it doesn't snap, something around 1.5 inches should do. The Hole is 35mm wide designed to...
thingiverse
Just a simple holder for your fishing rod. ...you can clip it on your belt for lure changing etc...
grabcad
A holder that I made to my fishing rods. Quite simple, but usefull. I didn't make the fishing rods. ...I borrowed it from here: Fishing Spinning Rod
thingiverse
Simple fishing rod holder that can be mounted to a wall or inside a boat
grabcad
Here a design of a fishing rod holder made out of wood planks. ...Homemade.
cults3d
Rod holder for fishing rods. One set of each will hold two sets of rods. ...Screw it into the boat and or sticky tape works perfect.
thingiverse
Fishing Rod Holder can be mounted with screws or attached with with 3M VHB Tape. ...Comes in 5in and 9in tall holders to accommodate different rod handle lengths,
thingiverse
This is a pivoting fishing rod holder to be bolted to a wagon, dock, or similar flat surface.
thingiverse
A fishing rod holder for use inside a sailboat. It can hold up to 5 fishing rods. Un soporte para llevar hasta 5 cañas en el interior de un velero. ...
thingiverse
I searched for fishing rod holder on thingiverse, but was unable to find a wall mounted one, as I wanted, so I designed one myself. ...You need two of these for one fishing rod.