fit bit 3d models
483610 3d models found related to fit bit.thingiverse
Bit Organizer Update 2018-11-03: I Noticed that the total length of the set was bigger than my case so I modified the set to fit in
prusaprinters
Simple low profile bit holder, if you have fit issues scale the STL up or down. 2-15-16 Added half handle version.
thingiverse
I designed this bit holder to store my Forstner bits inside my shop cabinet door. ... Printer in PLA, 20% infill, material not really important on this. Holes are size to easily fit 1/4" shank bits, and are about 1" deep.
thingiverse
This bit holder holds 12 bits and compactly fits in my tool roll and each bit can be removed independently. Printer: Metal Printrbot Simple Resolution: 0.15mm layer height Filament: 1.75mm Midnight Blue PLA Update: I glued 1/4" x 1/16" magnets in...
thingiverse
... access to the bits and the ability to store bits that are taller than the case is thick. The only issue is trying to get the bit bar in the bottom hole as it is a tight fit. ... Some filing of the bar may be required to allow it to snap in place.
prusaprinters
... tight places. They have a slot that fits a 6x2mm round magnet (cheap to buy in 100 lots) to help the bit stay in place while working. No supports needed and print in less than 30 minutes at .2mm layer height. ...There are three different bit depths.
cults3d
I made this little bit holder for a motorcycle enthusiast (cheers Bill) who needed to adjust a fuel idle screw. ...This small knob just might be what you need to sneak a bit into a place no mini-screwdriver was meant to fit.
prusaprinters
Handle that fits the standard ¼'' hex bits.There are plenty of great models of compact bit drivers out there but I couldn't find one that is the size of a “normal” screwdriver so I made one.Prints without supports
thingiverse
I made this little bit holder for a motorcycle enthusiast (cheers Bill) who needed to adjust a fuel idle screw. ...This small knob just might be what you need to sneak a bit into a place no mini-screwdriver was meant to fit.
thingiverse
Simple low profile bit holder, if you have fit issues scale the STL up or down. ...Based on my T handle for hex keys seen here.http://www.thingiverse.com/thing:951909 2-15-16 Added half handle version.