fossils stuff 3d models
33291 3d models found related to fossils stuff.thingiverse
27 Degree Mount for Fossils Stuff Gravity 250/280 Frame. ...Fits only with Runcam Sky+
thingiverse
Specifically to fit the Fossils Stuff Gravity 180 HS1177 or Runcam SKY (not Sky+) internals and lens fit to this case. Adjustable from 0 to approx 50deg upward angle. You will need some short 2mm bolts to secure the back, 3mm bolt and nut for the...
thingiverse
LED bracket for Fossils Stuff Gravity FSGX210 frame. Clips to rear, accepts led strip (3x) addressable LEDs. Superglue the LED bar to the clip/bracket (easier to fit the clip to the frame, check it, then glue the LED bar on, press parts together...
thingiverse
Use rc car antenna tubes like these http://www.modelsport.co.uk/modelsport-uk-aerial-tube/rc-car-products/1565
thingiverse
Print in TPU/TPE (flexible filament): For below the frame, between the motor foot and frame: FSGX210 softmounts Lower For above the frame (under motor): FSGX210 softmounts upper circle v1 or FSGX210 softmounts upper cross v2 Print in...
thingiverse
Mount for mobius/runcam. ...use small velcro strap (1.7 cm wide)
thingiverse
adaptation of my previous design:http://www.thingiverse.com/thing:1672634 to now fit the FSGX210 frame from Fossils Stuffhttps://www.fossilsstuff.com/ Hole spacings: Gravity 180 version: 43.3mm (left to right) and 41.4mm (front to back) (this...
thingiverse
Cam Holder (Top & Bottom) to Fit Fatshark TVL600 to Fossils stuff antigravity 250 fpv quadrocopter. ...CAM Holder is designed to have 10° degree angle Required for assembly: 4 Zip Ties 1mm/1.5mm 2 self cutting screws M3
thingiverse
Heavy duty casing to lower the stance of the camera (normally used with a angled mount = tall profile) and still provide 35degree of uptilt to the lens. Weight is about the same as original camera + a 35Deg mount etc. Weight can be lowered by...
thingiverse
Four versions of FPV camera mounting/protection for the superb Fossils Stuff Gravity 250/280 (1) cam_mount_v_1_3 10degree rise, fits most 32mm board cameras (usual suspects: Sony super HAD 600tvl etc) [this is a design by another designer not me,...
thingiverse
these cable covers can simply be pushed into the cable slot.
thingiverse
This Is a camera mount for a Runcam Swift. everything is friction fit and holds tightly with no hardware. ...It is made for bottom wiring and a 35 degree angle.
sketchfab
This is my design of dinosaur fossils andit takes place in a desert and has shovels and flgs to know where they started on this dinosaur tour.