frsky rx6r 3d models
2280 3d models found related to frsky rx6r.cults3d
This case is designed for the FrSky RX6R receiver. The paper cover around the receiver needs to be removed. Low tolerances. ###A lot of labor went into my designs. Designing, printing, testing, redesigning, retesting, .... I share my designs for...
thingiverse
This case is designed for the FrSky RX6R receiver. The paper cover around the receiver needs to be removed. Low tolerances. ###A lot of labor went into my designs. Designing, printing, testing, redesigning, retesting, .... I share my designs for...
thingiverse
:) Today I share with you my desgin of a Frsky RX6R Receiver Case with in-place-printed ledlight guide. This Part will not only protect your receiver and its flimsy antenna connectors, it also replaces the cardboard wrapping. This design ist pretty...
thingiverse
This is my hard case for the FrSky RX6R with v1 board. It replaces the flimsy card wrapper, offering much better protection. There is a hole for the bind button (note that there is no access to the S.Bus and SPort connector). The signal pin of CH1 is...
prusaprinters
<p>use a 6 pin pin header</p> <p>I used 2x4x8mm acrylic glass for RGB LED's</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Anycubic</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>All-metal...
thingiverse
use a 6 pin pin header I used 2x4x8mm acrylic glass for RGB LED's
thingiverse
A must have to protect the receiver along with the week cardboard shell. Mine was a perfect fit so probably wont need size adjusting. ...
cults3d
Hard case for the FrSky RX6R receiver. Offers better protection than the flimsy card wrapper supplied, makes the receiver suitable for high value gliders and electric models. There is a hole for the bind button. A dot next to the connector denotes...
thingiverse
Remix of the Rx6R case by rcsoar I added a hole for the S.port connetor and added markings of the channel numbers and pin orientation of the servo pins. I also changed the dimensions slightly for a better fit and removed the alignement tabs. Just...
thingiverse
I loved the quadcopter TX keychain by Mike-vorn-Mars (https://www.thingiverse.com/thing:2548116), but wanted an FrSky inspired version: This is a stylised Horus, X10 or Q7... you decide. It's designed to be printed as four pieces, 1 x TX, 1 x...
thingiverse
This housing was made to fit an Arduino nano, an MPU-6500 and a FrSky RX6R. ...I made this housing for all the components required to make an autopilot for an RC plane.